Recent content by pivert

If I sum up this topic, it's necessary to remove the weight of disk on the rear drive shaft to delete totaly all vibrations ?

Since I have a limited slip in the rear differential and that a Spartan blocking is not compatible. Is it possible to install a Spartan in the front differential without this being a problem ?

Yes, but for lot of money :Insane: And here, the dealership is FIAT group who does not know JEEP... The goal to switch for DANA 35 is also to use a PowerTrax because it isn"t compatible with current Chrysler 8.25" with limited slip box.

Thanks for your responses. I use my KJ mainly in offroad with big tire (245/75R16), rockslider, winch, skid plate, .... so much heavier. The main issue is that in France, the gear kit on 4:10 for a Chrysler 8.25" is really rare and very expensive. Someone would agree to send me...

Yes the goal is to replace both differential (front by DANA 30 and rear by DANA 35, both with ratio equal to 4:11). Actually, I'm already with drum brakes. I'm just scared of having problems with the DANA 35.

Hello, I have a question about the rear differential on my KJ. The goal is to have a gear ratio equal to 4:11 and I found a complete rear differential with this ratio but it's a DANA 35 and not a Chrysler 8.25 as actually. Do you think it's a good idea ? Thank you for your help. Ludo

Thank you for your help. I managed to get out the front drive shaft and fix it. Thanks to All

Dear all, I need to remove the front drive shaft on my Jeep KJ 3.7 to rebuild the CV joint on rear part, but it's impossible for me to remove it because the drive shaft is blocked by the exaust pipe on left side and the transfert case support. Can you help me please ? Thanks. Ludo

Do you know where to order this product kind ?

Can you tell me how to check the oil level of the 45RFE? 1. Start the car and let the engine in idle 2. pass all the ratios of the 45RFE (P -> R -> N -> D -> 2 -> 1 -> 2 -> D -> N) 3. In Neutral, check the level on the cold indicator of the gauge 4. When the engine is hot without driving...

What's new KJ604 ?

Thank you for the info, but I would have liked to find equipment already used, because the price is more expensive.

Hello everybody, I am looking for a Ring / Pinion kit with ratio equal to 4.10 for my JEEP KJ 2002 with DANA 30 front differential and Chrysler 8.25" rear differential. I live in France, but I can take over the transport costs. Thank you for your help. Best regards, Ludo

I confirms that following references used : 927 and 948 Checked on springs Envoyé de mon iPhone en utilisant Tapatalk

I will check this reference on springs during the replacement of isolators springs because the isolators from JBA are very bad quality (CROWN model).