Recent content by Patman1901
-
P
It cranks fine ,wont stay running
iv'e tried that, the pump runs and the gas pressure was 49 +-2 psi waiting on a pcm.thank you- Patman1901
- Post #20
- Forum: KJ General Discussion
-
P
It cranks fine ,wont stay running
i want to say thanks, i replaced everything but the PCM, allmost. i ordered a new PCM thats programmed and it was alot less than ive already put in- Patman1901
- Post #16
- Forum: KJ General Discussion
-
P
It cranks fine ,wont stay running
thank you! i ordered a new PCM for ir after it did the coils and plugs,and realized i didnt change that yet because everything shows the air temp but not the MAP,,, whats the part number? do you have it?- Patman1901
- Post #15
- Forum: KJ General Discussion
-
P
It cranks fine ,wont stay running
thanks,i bought the service manual,finally, and its great because it list the actions by the pcm and the sensors, it list the crank-shaft sensor as one of the first things to check,im putting it in now..i'll find out soon,since i've replaced all the sensors now the only thing leaft is the pcm...- Patman1901
- Post #11
- Forum: KJ General Discussion
-
P
It cranks fine ,wont stay running
it starts butdoesn't stay running for more than a few seconds, ive actually hooked the pump up to a spare battery so i can hear the motor in the pump run, im not getting juice to the pump with the key on to the acc spot,,yet if i pull the line off to the fuel rail and bump he key to start it...- Patman1901
- Post #10
- Forum: KJ General Discussion
-
P
It cranks fine ,wont stay running
Thanks for your help,thats something i didn't try ,or know..- Patman1901
- Post #8
- Forum: KJ General Discussion
-
P
It cranks fine ,wont stay running
i tried the gas cap trick,i was thinking along those line also-thank you ..ive noticed the air tube going onto the tank at the top of the pump assembly.what is the round bodied mechanism that that goes to ,it says "filter" on it but its not showing up on any filter i can see ,it sits next to the...- Patman1901
- Post #7
- Forum: KJ General Discussion
-
P
It cranks fine ,wont stay running
Great Idea- Ill do that ,thanks so much- Patman1901
- Post #6
- Forum: KJ General Discussion
-
P
It cranks fine ,wont stay running
Thank You- thats some good advice.- Patman1901
- Post #5
- Forum: KJ General Discussion
-
P
It cranks fine ,wont stay running
Hi, Just bought my first Jeep, 2003 liberty limited. its just getting to 140,000. It ran fine for 2 weeks then as im driving it just dies,like the key is turned off. so the first time i kept trying to get it started again and it acted like it was out of gas...even though it was 1/2 full,the...- Patman1901
- Thread
- Replies: 21
- Forum: KJ General Discussion
Staff online
-
GriffinNew Member