Recent content by Mytmouse

"If I'm unable to find the head light wires (hi & low beam) that feed both head lights before they split to each light, is there another way to wire the plow lights with the switch?" Right now I cut into the left headlight Hi/Lo beam wires , so now when I switch to the plow lights just the left...

I decided to replace the upper REAR A arm too. Was looking a little ify Used MOOG RK621376 from Rock Auto $118 shipped https://photos.app.goo.gl/tvHPbaQ9twh57PSJ6 Oh and BTW the fuel flapper fix worked - no more spill overs due to the infamous fuel BURP problem with the ethanol in the gas...

Alignment results https://photos.app.goo.gl/kNafpufteqXvTXNo8

Alignment results https://photos.app.goo.gl/kNafpufteqXvTXNo8

Sorry my bad just trying to keep all the info on the post for anyone in the future that may stumble across this post and need all the info to help them as well

Thank you Tommodd once AGAIN. I will relay this to the shop

*****HELP***** I just dropped off the Libby for an alignment at my local shop, and he said all he can do is set it to what the machine has for factory specs, unless I call the "lift company" (lol) to give him other specs to set it to..... Do you know what other alignment specs to give him...

*****HELP***** I just dropped off the Libby for an alignment at my local shop, and he said all he can do is set it to what the machine has for factory specs, unless I call the "lift company" (lol) to give him other specs to set it to..... Do you know what other alignment specs to give him...

Sota - while I got you - where were you able to find the head light wires (Hi & Low beam) that feed both head lights BEFORE they split to each light - for wiring in the plow lights?

Ha, so true - that's why I ask, I don't want to be one of those nimrods...

Another question - what's the best way to check the head light aiming and readjusting them, now that the truck is higher?

Another question - what's the best way to check the head light aiming and readjusting them, now that the truck is higher?

If you look at before & after measurements in the pictures it works out to be 4" more in front and like 3" more in rear. https://photos.app.goo.gl/xpV5PouLLUMdCmEN9 I re measured from approx center cap "hub" to bottom of fender flare fronts measure 22, 1/2" Rears measure 21, 3/4"

If you look at before & after measurements in the pictures it works out to be 4" more in front and like 3" more in rear. https://photos.app.goo.gl/xpV5PouLLUMdCmEN9 I re measured from approx center cap "hub" to bottom of fender flare fronts measure 22, 1/2" Rears measure 21, 3/4"

I measured from the floor to the bottom the the fender flare keeping in the middle of the center of the wheel... You want from the center of the wheel center cap?