Recent content by LFX1

  1. L

    What did you do to your jeep today?

    I didn't know they change the design from 2007 that much, what is crazy how that bolts up at the top, almost upside down compared to the older ones
  2. L

    What did you do to your jeep today?

    what are you expecting the charge on the spring compress to be ? I wasn't sure what was a good price for that.
  3. L

    What did you do to your jeep today?

    So what your saying is it was easy so I should send mine your way to clean up nice like that. Those look good!
  4. L

    What did you do to your jeep today?

    Must be a rabid squirrel
  5. L

    What did you do to your jeep today?

    The link for the front and rear go to the same page, can you post your front bumper link. thanks,
  6. L

    What did you do to your jeep today?

    That is pretty sweet, I been looking for something similar for my Avy, but buying one pre built is so expensive. I haven't seen to many good bumpers for the liberty, my younger brothers xterra has sweet aftermarkets, but same thing the company made good stuff, then closed shop. I would be happy...
  7. L

    What did you do to your jeep today?

    What gets me is these car companies want to cut cost but they make so many stupid decisions when it comes to accessories, like you mentioned some may require programming, or harness etc. If they would just use one default harness it would be so much cheaper production. I had a really cheap ford...
  8. L

    What did you do to your jeep today?

    you going to compress those your self? I picked up a pair I believe they are OME2790, depending on where you reference the part number, they fit my 2007 gas, but some sites show they are for the diesel CRD. I was told if I use them on a gas model they will ride hard if I don't have ARB or winch...
  9. L

    What did you do to your jeep today?

    does this ride hard with crd springs, what rear and front bumpers do you have. tire carrier looks different, off set, is that factory? Nice Rig
  10. L

    What did you do to your jeep today?

    Did you consider or know anyone who has used those TrakMotive CV's for extended travel for lifts, they have them for the liberty models. I wasn't sure the way that shaft can move in and out for travel would cause vibration on highway, I was looking into them, but haven't heard of anyone using them.
  11. L

    What did you do to your jeep today?

    Thanks, when I couldn't find 07 listed I just happened to look there as I that is where everyone says to get the diff mounts if you need them.
  12. L

    What did you do to your jeep today?

    Odd Liberty is an 07, but when I look for rack bushings they show up to 06, and say they aren't compatible for 07 and can't seem to find a factory part diagram to cross reference, looking at the rack the part looks like the 06, but odd all the sites either don't show the 07 part, or say the 06...
  13. L

    What did you do to your jeep today?

    Probably need replaced, but I don't feel any smacking movement, but ill review that. I know the sway bar mounts were replaced couple years back, but could be the culprit ill grab those and swap them out and check the rack ones. Least check it off.
  14. L

    What did you do to your jeep today?

    I'll check the sway bars. Originally when every thing was put in, nothing was torqued in the air, as we didn't want to bind up any of the mounts, my brother made sure those were in right, sway bar may need review. This started about 3-4 months after all of it was in, not right away. This is...
  15. L

    What did you do to your jeep today?

    We have checked them with load off the wheels, and the auto center checked them on the rack, and can't find anything loose, plus they were all new probably less than 1500 miles on them alignment takes as well. Believe me I been thinking of pulling them apart just to feel the joint, but the auto...
Top