lfhoward's latest activity
-
It was a regular caulking tube of outdoor 100% silicone window and door (exterior)caulking IiRC it took almost the whole tube to fill... -
lfhoward replied to the thread What did you do to your jeep today?.On my Commander it was the ESIM (emissions pump unit) clipped onto the charcoal canister in back. I also remember that not being very...
-
Haven't posted in years ,think last time I posted I had under 200k miles ...same ol Rocky road lift kit ,with Doetsch shocks since '18...
-
lfhoward replied to the thread What did you do to your jeep today?.An auspicious day!!
-
Odometer hit 111,111 on Saturday. Today is the 13th anniversary of the day I bought her.
-
Installed my logging road radio yesterday - tucked it away in the center console - didn't want it just sitting on the console next to...
-
lfhoward replied to the thread Lower ball joint loose in knuckle.^^^ If it were me I think I would give this a shot. The ball joint should have a snap ring that would prevent it from coming out, if it...
-
lfhoward replied to the thread Lower ball joint loose in knuckle.Interesting that the LBJ is only loose on one side. If you have a set of calipers, see if the difference is between the two ball joints...
-
lfhoward replied to the thread Lower ball joint loose in knuckle.That’s really strange! As you know the ball joint should have to be pressed in, even though the problem solvers have a snap ring to hold...
-
lfhoward replied to the thread Jeep Cherokee KK 2010 Limited sound system.Some KK’s had an optional sound system that included a subwoofer on the right hand side of the trunk/boot. These would have had a...
-
lfhoward replied to the thread P0201 Fuel Injector issue.I test drove it for 45 minutes, both city and highway. The engine has good power and idles well too. The Jeep runs smoother than before...
-
lfhoward replied to the thread P0201 Fuel Injector issue.The fuel injector is replaced and she runs! I let it idle up to temperature and revved the engine a few times and no issues. So far no...
-
Check out this stuff. Kinda like split loom but not brittle. Link
-
Everything is back together. Can confirm the front 4.10 gears I referenced in earlier posts worked, nothing blew up! Would be neat to...
-
lfhoward replied to the thread What did you do to your jeep today?.Can anyone recommend a good heat resistant wire loom that I can use in the engine bay? Most of my black plastic looms became brittle...
