lfhoward's latest activity
-
lfhoward reacted to rustydread777's post in the thread What did you do to your jeep today? with
Like.
Doing a shift kit, filters and new solenoid valve block. -
lfhoward replied to the thread P0201 Fuel Injector issue.There are o-rings where the injector seals against the engine on the bottom and the fuel rail at the top. But in this case, the gas...
-
lfhoward replied to the thread P0201 Fuel Injector issue.I cleaned the gas out of the connector area and wiped down the contacts, and turned the key to engage the fuel pump. No additional...
-
I hit the junk yard and got a new shifter, hatch latch and factory tinted glass for the hatch and fixed panels. The fixed panels were a...
-
lfhoward replied to the thread P0201 Fuel Injector issue.Following up this morning: The ground side of the connector is continuous with the correct pin on the PCM harness, so we can rule out...
-
lfhoward replied to the thread P0201 Fuel Injector issue.This is probably the Jeep’s natural reaction to spending $70 on a tank of fuel minutes before…
-
lfhoward replied to the thread P0201 Fuel Injector issue.It’s not a great photo because it’s dark out, but you can see the fuel residue on the connector to injector #1. The connector to its...
-
-
lfhoward replied to the thread P0201 Fuel Injector issue.Yes, that’s correct on the ASD and the PCM. And you’re right about Eric O. too! I’ve checked the power with the ASD energized and that...
-
Hi All, After loading up my groceries at ShopRite, I get in to drive home and get a check engine light, and the engine is running...
-
I dropped the pan on the transmission and changed out the filter but not before sucking the fluid out through the dipstick tube. I...
-
lfhoward reacted to DadOSix's post in the thread How To: Change front driveshaft / change a driveshaft head with Like.
Nice job! I have done a few - maybe 3x, but don’t recall the shift bracket info. Maybe I could have finished sooner. Usually pull the...
-
lfhoward reacted to HerronScott's post in the thread How To: Change front driveshaft / change a driveshaft head with Like.
Sorry to resurrect this thread but it was a big help (and of course I watched a few Youtube videos as well). Driveshaft Parts kits were...
-
lfhoward replied to the thread What "while im in there" things should I be doing durring a valve cover gasket change..While you have the valve covers off, check the amount of play between the rocker arms and the lifters (lash adjusters). If the lifters...
-
lfhoward reacted to jplgsx's post in the thread Problem with a door speaker that crackled - along with a solution with Like.
OK I have an 03 Jeep Liberty that I've done a lot of restoration to. I've leaned on Crutchfield for radio and speaker fixes and...
-
lfhoward reacted to Celticlady's post in the thread front end clunk, over speed bump - low speed with Like.
Put front on jack stands (on frame-not on lower A frames) so there is about a inch under tire. Use a long crow bar on a 2x4. Pry up on...
