KJowner's latest activity
-
KJowner reacted to spideyrdr's post in the thread Replacing rack and pinion bushings w/o removing it with
Like.
Thanks for the install PDF. I can see why they might do it that way - drop the diff and pull the steering rack back - but I can't... -
KJowner reacted to ikuo78's post in the thread Replacing rack and pinion bushings w/o removing it with Like.
Create Steel had replacement procedures. I'm not sure if they're still posted on their website. It looks like you need to remove the...
-
KJowner reacted to u2slow's post in the thread Replacing rack and pinion bushings w/o removing it with Like.
I changed those rack bushings pretty easy. Maybe 30 mins? Was a while ago, so I'm fuzzy on the details, but I do know the two rack...
-
UPDATE: My light is off now. Apparently mine was the valve on my evaporator canister (left rear of vehicle up high in front of gas...
-
KJowner replied to the thread 2008 3.7 4x4 Motor replacement.Get a CRD ;-)
-
I wish there was someone installing the 4BT Diesel!
-
I used the wipe on sealer that came with the 3M kit because I had too much other work going on at the time. If I had time to do it over...
-
KJowner replied to the thread What did you do to your jeep today?.Trick is to get them really tight, I've got a pulling tool that clamps the tail and sits on the cleet, then you just turn the screw to...
-
I've done it, but never had luck with it. In fact it's why I'm rebuilding my prop shaft again...
-
KJowner reacted to blackhawk's post in the thread KJ won't start, security light stays on. with Like.
In my opinion, firstly check why there is not 12v on pin 29. Connector c105 pin 5 12 volts should be present
-
KJowner reacted to blackhawk's post in the thread KJ won't start, security light stays on. with Like.
Pin 7 on data link as per my record do not have any function. The can bus pins are 6 and 14 , you must get 2.2 to 2.4 volts with switch...
-
KJowner reacted to blackhawk's post in the thread KJ won't start, security light stays on. with Like.
Check in the data link connector pin 6 and 14, they belongs to can bus. Take off positive cable of battery, you must get between these...
-
KJowner reacted to blackhawk's post in the thread KJ won't start, security light stays on. with Like.
I double checked..... Pin 27 is 5v supply instead of 19 (it must be empty) You must get 12v in pin 29. It's necessary for pcm and...
-
KJowner replied to the thread What did you do to your jeep today?.I sanded and sprayed mind with 2k clear a few months ago, came up like new, I can see in the dark again!
-
It does look great … maybe next on the to do list will be new headlamps … or at least a scrub, polish and UV seal. I used the TYC...
