KJowner's latest activity
-
+10pts for RUSH reference ;) That’s the job that I bought my first snap ring pliers for … very messy but fascinating the first time... -
This one feels like the OEM rubber compound so hopefully I will be pleasantly surprised.
-
End nippers Will do it, 10 bucks at harbor freight. Or if you know a plumber pex clamp pliers work too. Hope you're boot lasts. I...
-
One of the issues to repair from the lift failure incident is the CV boot on the drivers side. It got shredded by the springs exiting...
-
Put the front up on jackstands to check for play in the wheel bearings. I actually didn't feel any play or hear any grumbling from them...
-
Sure. I will have to grab a photo tomorrow. I thought I had taken one but it is of the old struts. When I’m done I’ll also let you...
-
A pair of freshly re-o-ringed fuel lines. So that's about a hundred bucks worth of stuff that I can put in storage for future use.
-
-
Back on three wheels!!! :p
-
Washed and waxed after getting new tires installed.
-
KJowner reacted to abowser_kk's post in the thread 12 jeep KK service 4wd, transfer case position sensor, gear ratio error with
Like.
So this is an update since I have gotten the problem fixed. the quick answer is the problem was the transfer case position sensor... -
KJowner replied to the thread HOW TO: Replace the alternator decoupler (clutch) pulley on a CRD.It's a bit of an involved way of doing it! Mine has a hex in the pulley so I welded 2 nuts together to hold it with a spanner so I could...
-
Back to reassembling the KK front suspension today. I can’t get it 100% done because an all-important clevis bolt arrives in the mail...
-
Well, I went deep and found out that bumper was made by Rock Lizard Fabrication, and he is out of the business. Huge bummer. So, I may...
