KJowner's latest activity
-
Today I worked on Jeepy to take the old shocks and springs off the front end. Hopefully tomorrow I can get the OME springs and Bilstein... -
KJowner replied to the thread 2006 CRD Limited Loosing Coolant... Pass Cold Engine Test..Is that where the leak is? The thermostat is easy to replace but if you have put thet horrible leak seal in the system I'd do a flush...
-
KJowner reacted to seafish's post in the thread 2006 CRD Limited Loosing Coolant... Pass Cold Engine Test. with
Like.
Those types of "stop leak" products should generally only be used as a LAST resort…like if youre stuck somewhere remote and need to... -
KJowner replied to the thread KJ won't start, security light stays on..Try starting it with the key in the run position when you flash the starter. If that works look at the keyswitch and the neutral...
-
KJowner replied to the thread 2006 CRD Limited Loosing Coolant... Pass Cold Engine Test..The tank must have some baffles inside it. Cold max fill is the seam and hot max is the small plastic line. I would find the source of...
-
Cost saving measure I am sure. They don't cut the hole, but you can see in the stamping where it should be. I chipped the textured...
-
Thank you I’m spending some money in suspension components, skid plates, fluids and a full tune up. Planning on keeping it for a long time.
-
Just want to say hello and post a pic of my new to me 2006 Liberty limited.
-
Thank you for you reply! Yes - that's what I am really afraid of, if valve guides are toast nothing would change. Anyways, I will give...
-
Any codes / lights on for ABS brakes? The rear abs sensor feeds the speedo - not sure if it affects the odo -
-
KJowner replied to the thread What did you do to your jeep today?.The rockers are structural in the unibody the thin outers cover some fairly substantial steelwork, there's a welded up box section...
-
Oh, adding to this... So the OEM clutch hose (on the prebled systems) is nylon fuel line (yes, the name is somewhat misleading)...
-
Should be able to just gravity bleed or bench bleed,… maybe the pressure bleed introduced microscopic air bubbles.
-
I have to say, it's looking more and more like this MUST be the case. I am going to be working on my son's XJ tomorrow (R&R the 2.5"...
-
Then maybe just a small air bubble in the line?
![IMG 20120721 154408[1]](/data/xfmg/thumbnail/5/5711-2e8f028dd1ef75f989f57f75c5aa32ef.jpg?1623784626)
