KJowner's latest activity
-
If you are putting anything back in there other than the very same carrier/bearings/shims/ring gear or any combination of the above... -
The friggin' clutch pedal popped off of that ******** plastic ball joint cage, again. Fortunately, right around the corner from my...
-
Just helped another Liberty owner with the stuck key situation in the ignition. Showed him how to remove the cable from the ignition...
-
I am getting my OME2927’s compressed and struts assembled so that I can rebuild my front suspension. They should be ready for pickup...
-
KJowner reacted to Liberty For All's post in the thread Six speed Manual Trans fluid exchange time/mileage schedule with
Like.
I refilled with Royal Purple Synchro Max so I can feel better. -
KJowner reacted to Liberty For All's post in the thread Six speed Manual Trans fluid exchange time/mileage schedule with Haha.
Yes, I called their corporate office and asked them to pay for a new plug.
-
KJowner reacted to Liberty For All's post in the thread Six speed Manual Trans fluid exchange time/mileage schedule with Like.
Yes, I had a muffler shop weld on a nut for $20 and found a new plug online. TY
-
Done job. It was more intimidating than bad. Although I had the luxury of a lift and a transmission jack. All done 3.5 hours. That...
-
The tanks should be the same. AA being the oldest and AC the newest. If for some reason I am incorrect someone will point that out.
-
tomorrow I drop the tank. All bolts were rusted badly, and i didn’t think they were coming out. HOWEVER, they zipped right out! More...
-
KJowner replied to the thread 2006 CRD power steering rebuild.I've never done one, you may be lucky and find it uses off the shelf bearings and seals, you would have to take it to bits and see. They...
-
KJowner reacted to David A. Warr's post in the thread Seized upper control arm bolt. Attempt to remove it myself, or admit defeat and take it to a garage? with Like.
i had to do this job on my Renegade. I had to use a hacksaw in my hand. It took me 45 minutes to cut through the bolt. Luckily the...
-
KJowner replied to the thread Rusted E16 external torx bolts for wheel bearing..Weld a nut onto the head of the bolt.
-
KJowner reacted to longboardskier's post in the thread Turn signal/Reverse light fuse keeps blowing with Like.
I pulled the center console out to access the wiring underneath. The red wire that goes to fuse #39 got pinched in the parking break...
-
Factory radios were pretty hardy. But not worth fixing or direct replacement. My Bluetooth receiver just went out. So it's time for an...
