KJowner's latest activity
-
KJowner reacted to LadyLiberty¹'s post in the thread Belt tensioner >> stripped@@*.* << mounting bracket with
Like.
I meant the whole belt tensioner...the ones I bought have had a lame spring that outlast the bearing. Found one on Amazon with a 5yr... -
KJowner replied to the thread Broken sway bar link bolt.Just make a shield from crumpled tinfoil for the lines, they are several inches away so it's only sparks you need to worry about (** as...
-
I mean, it runs without issues most of the time- I’m getting P0344 either right after start or within first couple of minutes of...
-
KJowner reacted to Patrick McGrinder's post in the thread Manifold Absolute Pressure Sensor Connector with Like.
I did it yesterday and it took a while but it worked.
-
KJowner replied to the thread Sensor issues.I doubt multiple sensors are faulty, have you checked the plug and wiring?
-
KJowner reacted to Isan's post in the thread ABS/Traction Control disables on low traction surfaces with Like.
I thought about trying that, but I would actually like a higher quality scanner, because I would be using it alot more that just once...
-
Always add the correct, specified amount of fluid first. To get a more accurate reading, drive the Jeep at highway speed for 30 minutes...
-
I always measure what came out to get an idea of what should go back in. Then check the level after driving it. Idk what an Lt is, but...
-
KJowner replied to the thread ABS/Traction Control disables on low traction surfaces.To get the system checked it would be much cheaper to ask a garage with a decent scanner to do it than spend a lot of money on buying...
-
KJowner reacted to Isan's post in the thread ABS/Traction Control disables on low traction surfaces with Like.
I actually found this exact issue while researching this problem posted somewhere else. That will be the second thing I check, first...
-
KJowner reacted to Isan's post in the thread ABS/Traction Control disables on low traction surfaces with Like.
If by coded you mean that it has to be programmed to the vehicle, I'm pretty sure this one does unfortunately, and I've heard rumors...
-
KJowner reacted to Desert Doc's post in the thread ABS/Traction Control disables on low traction surfaces with Like.
Check your wiring harness on the drivers side near the back seat where the harness goes through the body from the inside to the outside...
-
KJowner replied to the thread What did you do to your jeep today?.Don't boil it, bad things happen to the valve seats on the v6 if it gets hot!
-
Drained the radiator, changed the upper radiator hose, flushed the coolant with distilled water, replaced the thermostat, and am.now...
-
KJowner replied to the thread ABS/Traction Control disables on low traction surfaces.So it goes into fault when it's asked to function. JeepJeepster has some good advice, I'd check the ground cable very carefully, maybe...
