KJmurf
Last Activity:
Nov 18, 2017
Joined:
Mar 20, 2013
Messages:
57
Likes Received:
0
Trophy Points:
0

Following 2

Followers 2

Location:
Bend, Oregon
Occupation:
Keeping the wife happy...;)

KJmurf

Full Access Member, from Bend, Oregon

KJmurf was last seen:
Nov 18, 2017
    1. KJmurf
      KJmurf
      The pics are in my Fabrication album. Also, I used the "indentation" on the fender well as my bending template. That indentation can be seen in some of the pics when the fender is off. Tip: When using the pipe bender on steel tube, you use the bender die that is 1/2 " smaller than the tube you are using, ex., I used the 1/2" die for 1" steel tube. When I made my rock sliders, I used the 1 1/2' die for 2" steel tube.
    2. KJmurf
      KJmurf
      Sorry for the delay, I have not been on the site for a long while. I did make them. I used a harbor freight pipe bender, 1" tube steel, some plate steel, and harbor freight bedliner. I think there are some pics on one of my albums. After taking the fenders off, I used the existing hole locations for my 1/4" bolt locations. Let me know if you need anymore info. I will tell you that it was a pretty fast project, just a lot of "bend pipe" then "eyeball", repeat process.
    3. MacAndrew93
      MacAndrew93
      Hello, I noticed those awesome fender flares on your Liberty. I like that style and have been wanting one's like those on my liberty but I can't find any. Did you make those yourself? Did you buy them? Any help you could offer would be greatly appreciated.

      Thanks, Awesome Jeep man
    4. KJmurf
      KJmurf
      Sorry...for some silly reason I thought you were sending them to me, but I see the benefit of posting for everyone...guess I'm just a selfish SOB. Looks awesome and a great fit.
    5. profdlp
    6. KJmurf
      KJmurf
      I have no doubt...
    7. profdlp
      profdlp
      I will soon. The front seats looked so good I am planning to take out the back seat and make sure it looks equally good. Been on the phone all afternoon doing job interviews. (I think if those folks could see my smiling face in person I'd have a better shot at getting hired.)
  • Loading...
  • Loading...
  • About

    Location:
    Bend, Oregon
    Occupation:
    Keeping the wife happy...;)
    Grew up in Newport, OR...USAF after HS...Sheriffs office for a few years...U of O accounting degree

    Archery hunting, fly fishing, camping, you know Central Oregon stuff.

    Signature

    2004 KJ Limited
    Tommudd's Econo 3.5" Lift w/JBA UCA's-255/75/17 BFG KM-DT w/Hammered pinchwelds. Nitro 4.10 gears w/rear Powertrax No-Slip locker. Thrush welded muffler. Custom bumper-Self-fabricated rocksliders,roof rails, and front steel fenders. Budget roof rack basket-Thank you JSCHERB!!, rear swaybar removed & drive shaft "neutered".
    ON THE LIST:
    DOES THE LIST REALLY EVER END?