JustSumDad's latest activity
-
JJustSumDad replied to the thread new to forum. jeep liberty issue.just gonna say, if the body has zero to very low rust, I would fix that motor. don't suppose your anywhere on Vancouver island :)
-
JJustSumDad replied to the thread new to forum. jeep liberty issue.its worth grabbing a cheap Bluetooth scanner and get an app on your ph, you can get them literally under $10 I use an app called Torque...
-
-
JHead gasket leak is a common problem of the 3.7 pass 100k, just resurface the head and get a new gasket. The most critical part is get a...
-
JI was recently trobled by the same code P0507 for my 2007 KJ. I first replaced the drive by wire ETC throttle body but no help. Did...
-
JWill report back once I get them installed or not. In the process of regearing the front right now
-
JJustSumDad replied to the thread 2003 KJ - fail of 4wd for a short time..ok, this is makeing some sense, tho it was quite a bit of messing about to get it to lock in... I was on an icy hill, brakes on no wheel...
-
J2007 was a cross over year before the KK Jeep, it may not have a IAC. Here is what the IAC looks like.
-
JJustSumDad replied to the thread P0507 Code but idle seems fine.I believe your issue is in fact the IAC system and you should clean the ports to/from it. I believe the idle is just a little higher...
-
JJustSumDad replied to the thread 2003 KJ - fail of 4wd for a short time..thats really weird to me, but I dont actually know how the tcase is setup... I thought the lever ran a cable direct to the tcase...
-
JJustSumDad replied to the thread 2003 KJ - fail of 4wd for a short time..After exploreing a bit, it seems the Libby does NOT have any form of hub disconnect... So hopefully someone can tell me why I was not...
-
JJustSumDad replied to the thread ASFIR 4x4 skid plates.I look forward to hearing from you on this.
-
JThank you. I contacted them and they said they were unable to confirm due to only testing on CRD. I know on the gas KJ the transmission...
-
JJustSumDad replied to the thread ASFIR 4x4 skid plates.Yes but the question is will they fit a 3.7L gasser.
-
JSo today I was driveing on wet pavement on the hwy and thus in 2wd, I turned off onto a packed down snow road and on the fly but at slow...
-
JJustSumDad replied to the thread ASFIR 4x4 skid plates.Suggest you contact them to make certain, Since the CRD KJ had a different transmission than the gasser after 2002/03 perhaps they only...
