Recent content by jtalef

Could anyone get the following part number for me, please? 2003 tail gate (slate), interior trim panel. It's the large, one piece panel that fits onto the inside of the tail gate. I discovered it's the source of my tail gate rattle; two retaining clips are broken on it. Thx.

How does one go about modding their existing clockspring? I am going to try and tackle this project over the weekend and given the recent prices of the wiring harness ($81.45) and clockspring ($144.00) I'm thinking about modding it instead of replacing it.

Welcome to the site. It's been most helpful to me these past four years as well. Looks like you've got the Sport edition. Nice Jeep, now it's time to start modding it! :)

Something to note, this is only an applique' package. Basically a "sticker" that you place over your existing console to improve or change it's appearance. The actual replacement radio and shifter bezels in the brushed aluminum look are rather expensive. I upgraded mine on my 2003 by...

Can this thread be moved to the electronics section? I may get a better response there. Thanks!

Looking for some insight here. The temperature sensor in my Jeep seems to act up between 70 and 80 degrees F. Anything above or below those temps display properly but, that range of temps causes the display to indicate -40 to 23 most of the time. I tried replacing the sensor itself but...

I just replaced mine yesterday. Getting the red tab to pull out was a beast of an effort. Not sure if it was just because it was so cold outside or what but, I would up having to use a paint can opener to pull it out.

Docking Cable Routing I'm still waiting on my replacement. ](*,) A quick question. How did you route the docking cable behind the glove box. I tried to do it as illustrated and there was no way it was going behind all the stuff they show it behind in the instructions.

Thanks Bob, I'll try a swap out as well and see what happens. For the part number you meant the part number of the iPod kit itself correct? Can you provide me with the correct part number for the iPod kit? Or are they all the same with the exception of the last two letters? Jason

Hi Bob, Thanks again for another quick response. Question, make sure the Mopar iPod Kit part number ends with AC? My RB1 is older it has the DVD ROM logo on the face of the radio. Could this still be an issue? Also, you're exactly right, it wouldn't even charge the iPod when...

I too received an iPod kit today and unfortunately, it didn't work when I hooked it up to my RB1. It also didn't work when I tried my RBQ. I hit CD/AUX on the RB1 and nothing, I hit 'Mode' on the RBQ and nothing. The iPod didn't even say it was charging when I plugged it into the dock...

I couldn't find a how to on this and I probably should try and clean mine out. Is there anyone here that can offer up a "how to" or give me some pointers? I'm sure it's not rocket science but, a little good advice can go a long way.

Thanks, I gotta start using that search feature... #-o

Would someone be willing to post a few pictures of their RB1 with the Mopar iPod kit in operation? I'm curious to see how it operates and what it displays. Thanks!

I bought it new but, I can't even find the blower motor to remove it. Does anyone know how to remove the blower motor? Also, would a bad resistor cause the blower motor to make a noise at low speed? The noise is only present at level one.