Recent content by Joeyd900

Scratch that, second pic mannifold is mounted to head.

Exactly, its a perfect machined step down on the mating surface. Someone must know.I will take more pics tomorrow, but, there is a fourth hole on the cyl head directly underneath the step down as I call it. As for second pic, pay no attention to the placement of the mannie to the head in the...

Dismantling 3.7, P.S. head off, then I see this. Is there a reason for the noticeable step-down gap on the Driver side manifold? Is something missing in that gap I should know about before reassembly? Why a gap between the gasket and manifold? help, I can't find anything on it.

MY wife had same problem 03 sport. I tightened up her engine splash shield and viola no more rumble at 55+. It was rattling against the cross member. Prob not you problem, but food for thought

Ok, so traced DG/WH, ground behind battery loose, figured out only 12v for a second or two at fuel pump. Found a pinch in new fuel filter line, , no pressure at rail. Fixed problem, suddenly 7 new codes up. So, I start with the lowest numerically, Cam sensor failure, hmmm didnt I replace that...

03, auto, after new head gaskets, timing chains/guides,new Cs and Ck sensors, fuel pump/filter, et al, only 7 volts at pump. PDC Fuses and relays good. Jumped fuel pump- its good. No pump prime. Is there a reset switch for asd ?