Recent content by Jeremy6305
-
Detroit Lockers with Selectrac
Thanks for helping clarify that. I did not want to put out six or seven hundred dollars and be stuck, so to say. Thanks again.- Jeremy6305
- Post #11
- Forum: KJ General Discussion
-
Detroit Lockers with Selectrac
Hello Tom, I am looking to put a DTT in the front of my 2002 KJ. I have read and heard that that would not work because of the pinion shaft is longer. Is this true? From the post I read here there is really no problem with them.- Jeremy6305
- Post #8
- Forum: KJ General Discussion
-
Noise's again
Did not suggest that but I went with the budget lift from RRO and had some bumping until I changed control arms. It is a lifted off-road vehicle it is not going to be silent going over bumps and potholes.- Jeremy6305
- Post #15
- Forum: KJ General Discussion
-
Noise's again
Maybe mistaken on the 2.5 lift. A `1-3/4" spacer adds close to 3" and a 3/8" plate will add another 9/16th's for around 3.5 of lift so if you are not considering the actual lift height and just spacer thickness. idk good luck- Jeremy6305
- Post #11
- Forum: KJ General Discussion
-
-
Multiple O2 Sensor Codes, Sensors Already Replaced
Had the same problem due to bad cats causing them to get to hot. Changed the cats and was able to reuse the O2's. No codes now runs great.- Jeremy6305
- Post #7
- Forum: KJ General Discussion
