Recent content by jblake1986

I got the code for an ignition coil replacement today. How hard is this to do? Can anyone give me instructions? I have an 04 liberty 3.7.

But what would cause the glass to not open as well?

04 liberty when I try to open the window/hatch with the handle on the back it does not open, but if I use the keyless entry the glass works fine. I opened the access door on the inside of my back door and when I pull the lever I can feel it moving, but the door doesn't open. Does anyone have any...

Great! does anyone have a FSM or diagram for replacing the tensioner with both pullies? I would also really appreciate a part #. Can you help me?

Pully So it almost looks like the pully that is broke is the one attatched to the tentioner piece to take the serp belt on and off. Is that still considered an ideler pully? Also what is the process to replace the entire tensioner assembly and do I need to do that in this case?

$40 for the belt and $17 for the pully. Do I also need a special tool to get the belt back on?

fair enough.

Anyone know the cost on the pully and belt? JW for a ballpark

OK I was about a mile away from home today when my battery light came on and my heat temp was a little hot. I turned the heat on full blast and got home. When I got home I noticed the serp belt was off where it should be. It was still attached for the most part minus the pully. I then noticed...

Im back with another question. I have noticed my AC is not as cold as it used to be and was wondering what ideas you may have? A guy I know was going to put freon in, but when he hooked up the can it showed I was at full pressure. It seems to get fairly cold if driving, but sitting still it is...

The waterpump was replaced about 2 years ago. I went home last night and took off the water pump last night and sure enough the impeller had shattered. All the pieces were in there and I took it back to the parts store where I purchased it and was given a new one free of charge which had a metal...

Well and with the little testing I could do yesterday when I took the cap off the resiovor the heat became warm like it is supposed to. Almost like a vacuum is not being kept right. I have replaced the water pump before so it is under warranty and I will probably replace it just because. Also I...

Please advise on how to properly do a flush

Will do That will be the first thing I try when i get home, do you think replacing the cap on the resiovor would be a good idea since it is so cheap?

Also it looks like the electric fan is running.