-
-
Quick Update (2) Oem Engine Core Plugs “one above the starter, one above the right motor mount New Front right Motor Mount Oem Mopar... -
ikuo78 reacted to duderz7's post in the thread Rear suspension or axle clunk when getting on or off the gas. with
Like.
Jack it up by the axle so it's closer to ride height during inspection. The bushings mentioned would be a good place to start, next the... -
ikuo78 reacted to u2slow's post in the thread Rear suspension or axle clunk when getting on or off the gas. with Like.
Upper arm bushings. They tear. Best viewed when not jacked up. It is very difficult to remove the OEM bushings without stretching the...
-
ikuo78 replied to the thread What did you do to your jeep today?.But I would be in trouble if this method completely fixed the oil leak. The plastic valve cover, which cost $120 including shipping, has...
-
Sometimes you can't get them to stop leaking without using the u shape with the two wings so it pulls down on more of the cover. Old...
-
I couldn't wait, just went and put one in. It the rh side, drivers side here in the UK. I swapped the nipple's to grub screws, didn't...
-
ikuo78 replied to the thread What did you do to your jeep today?.The valve cover is still dripping oil. I removed the grommet from the mounting bolt and checked the tightening, but it was only...
-
-
ikuo78 reacted to u2slow's post in the thread Looking the upgrade my suspension on 2005 jeep liberty with Like.
Bilsteins aren't worth paying extra for IMHO. Ours had them on the rear and I went to Monroe's after lifting. On my Dodge, Bilsteins...
-
ikuo78 reacted to KJowner's post in the thread Looking the upgrade my suspension on 2005 jeep liberty with Like.
H&R springs and some new shocks will freshen it up nicely.
-
Yesterday I pressure washed Giddyups underside to prevent as much dirt as possible from falling into my eyes as I dropped her fuel tank...
-
In order to finish off the in tank LP install, I drilled a hole in the unibody, behind the drivers seat and under the carpet, for the...
-
Wifey had major surgey and is recovering well, so finally had some time to work on Bert in between wound care and drain purges (gross...
-
ikuo78 replied to the thread Engine/Crankcase Breathers.I am trying to do this to lower the pressure inside the crankcase. The breather hose connected upstream of the throttle is basically...
-
It works but its very aggressive, wouldn't recommend it if other derust products are available, very glad I greased the bits I didn't...
-
All dry, still look rough but with the pitting that's not a surprise, the bores are still slightly greasy so hopefully the overspray...
-
-
Loading…
-
Loading…
