GnomeKing
Latest activity Postings Resources About
-
-
David - does your scan tool do live data? If so, see if you can find both the cam and crank sensor voltages and signals. Should be 4... -
GnomeKing replied to the thread Camshaft Position Sensor.I replaced both with NTK, no difference
-
I got my hooks from deadjeep. https://deadjeep.com/search?q=tow++tag%3aliberty
-
GnomeKing reacted to joooooooooop's post in the thread New Jop, what should I do to it next? with
Like.
Hello everyone. I just picked up a 06 KJ a few months ago in SE Michigan. Only 75k miles but still predictably rusty. Already spent... -
Official service manual for KJ - 2005
-
GnomeKing reacted to Xmcracer's post in the thread 07 liberty turn signals and flashers quit working with Like.
well, I must say that is a really stupid design.. engineers these days evidently never heard of the kiss principle. the old days were a...
-
GnomeKing replied to the thread 07 liberty turn signals and flashers quit working.When I was researching LED bulbs for turn signals, the conclusion was that you have to use resistors, because relays for turn signals...
-
GnomeKing replied to the thread 07 liberty turn signals and flashers quit working.AFAIK the flashers don’t have its own separated module, it’s all integrated in hazard light switch at the center of the console...
-
GnomeKing reacted to Patrick McGrinder's post in the thread Manifold Absolute Pressure Sensor Connector with Like.
I did it yesterday and it took a while but it worked.
-
GnomeKing replied to the thread Sensor issues.I replaced both using NTK, no joy
-
GnomeKing replied to the thread Sensor issues.I mean, it runs without issues most of the time- I’m getting P0344 either right after start or within first couple of minutes of...
-
I doubt multiple sensors are faulty, have you checked the plug and wiring?
-
Not from the factory it doesn't lol.
-
GnomeKing replied to the thread 2002 Jeep Liberty coolant bleeding nut rusted shut.I was able to get mine out after soaking it with PB Blaster and gentle tightening/loosening. I put a bit antiseize on it afterwards. I’m...
-
Ok so first things first. Pull the cover. It's not hard. This give your the opportunity to check your guides and replace anything that...
-
-
Loading…
-
Loading…
-
Loading…
