Recent content by GloryIsForever

There is a little carbon build up. Other then that tho pattern looks good. I don't see any reason after the resurface to put it back together. The seats look good. Honestly I can't afford to replace them right now. Maybe in the future.

I got the head off! The gasket was nearly welded on. Now I have cleaned the block and head off with a bit acetone and some steel wool. The head however seems a bit warped. only in 1 spot near cylinder 6. I assume this is where the gasket had blown due to heat. So now I'm going to have the head...

Thanks for the reply. Problem is only way I can get at the manifold is if I take the radiator and disconnect the AC. Two things I don't want to fool with. According to everything I have looked at from the manufacturing manuals the head is held on by 12 bolts. I have taken these out so if...

Update Every bolt holding the head to the block has been removed. The exhaust manifold is still attached to the head. I still cannot free the head from the block. I know how it sounds but I like to think i'm pretty damn strong and bracing myself against the Jeep and pulling the head and it will...

Thanks for the reply, and thank you for your support. So I did remove the sprocket to also inspect it closer and it does have some wear so I may replace it. So I'm pretty sure I have everything need removal removed. But I cannot jig the head loose. I don't want to damage it or maybe I missed...

Pictures As promised. The to pictures of holes are from the plug holes in the back 2 passenger side. The copper shavings are from a quick seal that he tried before knowing what was wrong.

Hello everyone, sorry I didn't post an introduction before this but I'll be quick, Name is Craig. I live in FL. I recently moved back here after a few years on Camp Pendlenton as a 1371/Combat Engineer in 1ST CEB. I am 24 with one beautiful boy and a little girl on the way. I'm serving out the...