Recent content by frankmacer
-
F
trans cooler lines
I am doing it at present, the 2006 that I am working on has clips, you need a pick to remove them, and a pair a needle nose pliers, take you time with them please, don't lose the clips, please put penetrating oil on the connections over night, remove the plastic protector gently,and then use a...- frankmacer
- Post #48
- Forum: KJ General Discussion
-
F
Starter Cable
I thought it was the starter on my 2006. Jeep liberty with just about 200000 miles. Turns out it was the lug on the starter. And it had rotted and the car would not start. It cost me a 110 bucks to have the lug replaced. I wish I could have found it because I am electrician and I could have done...- frankmacer
- Post #4
- Forum: KJ General Discussion
-
F
2007 Jeep Liberty Bilstein 5100s and lift springs
Did you install it yourself, or did you have it installed, if so what was the cost? I did a Rusty's lift kit on my truck and cost me about 250 bucks for the kit and then it took me a few hours to install, I installed it with the help of my dad right here in my own driveway. Only thing I don't...- frankmacer
- Post #14
- Forum: Lift Kit Discussion
-
F
Too much lift?
Be extremely careful when using the spring compressors make sure they're bighting correctly if you have to tie them on with tie wire and make sure they're bighting correctly, that way they don't release accidentally.- frankmacer
- Post #9
- Forum: Lift Kit Discussion
-
F
Too much lift?
You will definitely need spring compressors in order to put the car back together, it's pretty much the only way that I was able to do it. They're cheap and I think Advance Auto or AutoZone has them- frankmacer
- Post #8
- Forum: Lift Kit Discussion
-
F
Too much lift?
Good morning I I installed a Rusty's 2. 5 inch lift in my 2006 Jeep Liberty Sport, other than having to replace ball joints every few years it's been great. I went with the next size up Tire which is a 235 70 16 instead of the 225 75 16s, and I also installed a 1.25 inch wheel spacer on each...- frankmacer
- Post #7
- Forum: Lift Kit Discussion
-
F
Replacing front hubs
Hey, you can do it, you just need the sockets to release the Hub from the back it's a specialty socket I'm not sure what its called. it's like a star socket or something, you can buy it at Harbor Freight they're not expensive at all. you need to soak everything in penetrating oil the day before...- frankmacer
- Post #12
- Forum: KJ General Discussion
-
F
Front Suspension Squeak
What wasn't tight, my guess would be the nut that holds the stut plate on? Is that correct. I had bought new struts, is it possible on a new strut their FCS struts so they're good stuff. Let me know please thank you.- frankmacer
- Post #13
- Forum: KJ General Discussion
-
F
Front Suspension Squeak
Front squeek Have a front end squeek, it is usually when the car shifts around, I greased all the suspension components, from the top of thr strut to the lower ball joint with white lithium grease. It help a little, and for a little while. I changed the sway bar bushings, and greased them...- frankmacer
- Post #12
- Forum: KJ General Discussion
