Recent content by dustinward03

Compression is good. Have voltage at the no 1 coil connecter. Order another new computer just to rule out that I got a bad one. Does anyone have a wiring diagram so I can check my wires from ecm to coil plug.

Has a miss at idle but rpms are steady doesn't go up or down. No my tester isn't long enough have to borrow one off a friend monday

Tested wires from ecm to ignition coil 1, wires both ohm out from connector to connector. For the last post it does it on acceleration, for example, you take off and a going 25 miles an hour. You floor it and it will immediately act like it hits a rev limiter, will bounce the rpms but not...

I will test compression tomorrow. And I will try to unplug and replug the knock sensors thanks for the info and I will update as I go

Will do it around 3000 rpm in park or neutral, will do it anytime you go over half throttle when in a driving gear.

Just something else to throw in. When u are driving if u keep if half throttle or so its not to bad. If you floor it its like hitting a rev limiter until u let of the gas then it will go again. If yoi don't let off the gas it will continue to slow down until you either stop or let off the gas.

Would a vacuum leak or bad compression throw a p0351 code?

Here is my story. 02 liberty limited 2x4 3.7 auto. At 106,000 miles had missfire with no codes. Took it to dealer they replaced lifters and cam followers for cylinder 2. Got jeep back. After 2 weeks presented with same problem. Took it back in they replaced all lifters and followers. Got the...