Recent content by cleaf

  1. C

    jeep -04 kj renegade "backing plate"

    car has been crashed on drivers side rear tire . and that part is completely broken where you attach handbrake shoes. old axle is replaced with new one. and "backing plate" part what i mean is supposed to be installed on those 4 bolts
  2. C

    jeep -04 kj renegade "backing plate"

    Hi Can you fit backing plate from another model? (i mean that part where you attach handbrake etc..) New ones in this model are so expensive
  3. C

    jeep cherokee -02 3.7 P0500 fault

    Havent opened old module yet, just did replace old one to new and it did the job.
  4. C

    jeep cherokee -02 3.7 P0500 fault

    finally i did found where problem was, abs control module was "burned". changed it to new and jeep rocks again! thanks for the help!
  5. C

    jeep cherokee -02 3.7 P0500 fault

    https://www.rockauto.com/en/moreinfo.php?pk=1320666&jsn=3&_nck=Ekt6BqBF1pwlXdx0gYlm1esw98pF26vehMm%2FGG3C%2Fl2QOXSJubi7WaPjz7KO9EMWuPWUQmbqKkRBtVBM64hlzeHJB%2FZX4jE3YinsmGpzNxY2KkWbYxtgOsYAFrqXlFQUpir62N0nlZz%2FcnkjMtM4cNMe19l5ZkuDfpsJQM7v3IByor1nFVXnW8ccYwAnyLsLrNu1gB%2FT99IgcgFFX2AiLFfKpPjixZTG...
  6. C

    jeep cherokee -02 3.7 P0500 fault

    sensor has been replaced. ABS light is on when you start car and speedo doesnt work. checked to continuity from sensor to abs module with multimeter "beeper function", cables also seems to be ok. it doest give any fault codes now but still speedo doesnt work and abs light comes on...
  7. C

    jeep cherokee -02 3.7 P0500 fault

    i did remeasure sensor and got some readings. old one 3Mohms New 0,439Mohms.
  8. C

    jeep cherokee -02 3.7 P0500 fault

    i have changed sensor what is located in top of the rear diff. fault it still on? i have checked wires too and they looked ok. i did measure ohms on old sensor and new sensor but meter shows 0ohms so are both sensor broken? speedo doesnt work.
  9. C

    jeep cherokee -02 3.7 immobilizer problem?

    ok il check SKIM too. Does radio have something to do with this fault? It all began when radio started to burn fuse???
  10. C

    jeep cherokee -02 3.7 immobilizer problem?

    Yes engine will turn over but wont start. I measured pin 30 and it shows +12V so thats ok, mayby i try to check that pin 87 wiring is that ok. model is 2002 cherokee 3.7 Immobilizer light comes on when you turn key, turns off for a second and comes back on without blinking. Can you check...
  11. C

    jeep cherokee -02 3.7 immobilizer problem?

    ok some progress. no spark. Tried to unplug and replug SKIM, nothing happened light still comes on. And i have only one key to car. ASD relay wont operate, if you put ground from straight from battery it will operate. In pin 30 comes 12V. Tried to jump pins 30 and 87 but it didnt start and...
  12. C

    jeep cherokee -02 3.7 immobilizer problem?

    hi car will crank but wont start, it keeps blowing fuse 34 (radio etc..), i have disconnected radio and fuse doest blow so radio is broken. immobilizer light wont turn off on the dash so can radio can have something to do with immobilizer, it has that immobilizer blinking light on it. it did...
Top