CheddarGau's latest activity
-
CCheddarGau replied to the thread 4.10 gear finally Installed.Yeah buying it ahead of time, making sure its set up properly and slapping it in, is just easier. The front was always going to be set...
-
CCheddarGau replied to the thread 4.10 gear finally Installed.Did it myself, I got close, I didn't have extra pinion bearings on hand to make a set up bearings. I had assumed we had the pinion depth...
-
CFinally got around to installing my 4.10 gears in the rear. Couple reasons for this. Upgraded to some larger tires a few months back...
-
CCheddarGau replied to the thread Front differential help.Just curious, but did you also re-gear the rear diff when you re-geared the front diff? How much did the front diff assembly rotate...
-
CCheddarGau replied to the thread What did you do to your jeep today?.I finally got around to fixing my O2 sensor heater circuit. Found pin to be pushed half out
-
CCheddarGau replied to the thread What did you do to your jeep today?.I'm actually a fan of their look. Rarely see the electric ones here. They are nice and easy to parallel park.
-
CCheddarGau replied to the thread What did you do to your jeep today?.Laziness is hard factor multiplier. He's lucky to have completed the task at all!:p
-
CCheddarGau replied to the thread What did you do to your jeep today?.Is it wrong to have a semi chub?
-
CCheddarGau reacted to Luke's post in the thread Seized upper control arm bolt. Attempt to remove it myself, or admit defeat and take it to a garage? with
Like.
Heat is magic! I would try that before the more destructive options :) -
CFWIW, I recently replaced my 2009 KK’s LCA’s with Moog units. The Moogs appear to be higher quality than the OEM LCA’s. I like that...
-
CCheddarGau replied to the thread 2008 liberty 3.7.spidertrax may have wheel adapters. I thought I saw some, but could be mistaken. Might actually be cheaper to find some 16 or 17"...
-
CCheddarGau replied to the thread Front differential crush washer/pinion nut torque 500 ft/lbs??.Yeah the torque spec vs real world torque required to get the correct pre-load aren't the same haha. 24Turbo is correct, crank it down...
-
CCheddarGau replied to the thread What did you do to your jeep today?.Went to wreckers picked up a new coolant tank, $15 is worth the gamble. I checked the vin ahead of time and found the liberty next to it...
-
CCheddarGau reacted to joshgoble's post in the thread Engines & PCMs, Trans & TCMs: Exact part number matching is mandatory with Like.
Depending on the year and your equipment you can edit the PCM and TCM an match the parameters to what is needed. If you cannot get the...
-
CCheddarGau replied to the thread Engines & PCMs, Trans & TCMs: Exact part number matching is mandatory.Needing to have vin programmed into the PCM, TCM, BCM, etc is nothing new. Part number refers to a couple things on Chrysler vehicles...
-
