hi,
the jeep has some progress i have finished the fuel system. but i still have to wire up a relay for the fuel pumps.
i also installed the clutch petal and brake petal assembly.
i have just been busy lately i started a new primary 7-4 job and im still helping my previous employer with a...
Yeah here's a pic of her front and rear end.
Just ordered more an fittings just now. By the end of this I'll have $300 in an- hardware/hose/fittings
The engine is sitting a little bit off because the transmission mount and cross member is off right now it's being held by a jack.
Update
Things are going good.
1. The engine/trans is bolted in
2. The fuel tank has been dropped and drained/preped
3. I have my liberty clutch petal and brake petal ready to install
4. I have a liberty clutch master cyl but i may not use it because its wimpy and plastic. i do have a...
i got a few things done this weekend unfortunately i had to go to work for a few hours over the weekend and it kinda threw the plans off a bit.
1. i made the motor mount holes bigger on the cross member so the engine mounts fit.
2. i was not able to weld the transmission mounts together so i...
thats a great question.
1 the speed sensor on the liberty is on the differential. it works automaticly
2 temp sensor i'm using a stock one and the stock harness will plug into it
3 fuel gauge it will work i'm not messing with that
4 i need help with this one or i will have to use a...
this project is not a long term project. its a get it done and drive it asap project. i already have 2 long term project cars 1 is 98% done (93 300zx z32 fully built twin turbo convertible no corners cut) and the other is still sitting on my car hauler from picking it up on saturday (91 300zx...
I picked up my drive shaft today.
2000 ford mustang automatic 47 inches
I also learned that my stock power steering line works great with the sc400 power steering pump i just need to pick up a 1/2 inch flared 90* fitting male to female ($4 at autoparts store)
So thats 2 steps forward...
I really didn't take much out of the engine bay. just the engine it's self and the harness. That toyota v8 is about exactly the same size all around as a 3.7.
The toyota 1uz v8 is aluminum and is actually 20% lighter than the 3.7 and the transmission is lighter too by far maybe 25% of the...
its a 2wd if it were 4x4 id use a toyota truck transmission and t case
its the stock rear with 3.73's i don't plan on having much traction i'm not going to put slick on it or real wide tires maybe a 234 or 245 / 60 or 65 / 16.
i may end up finding a 8.8 out of an explorer or something to...
i want to see that ls2 swap happen. then maybe ill have a fair liberty vs liberty race.
this s/c was pushing out 12lb of boost on a 10 to 1 compression. in the drift car he blew the headgaskets on the first track event in orlando. now it has cometic metal head gaskets and arp studs to match...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.