Recent content by bjeffers83

Via email with arb usa I have attached our Liberty KK guide. It states that the 2731 springs will provide approximately 1.5'' of lift for the rear. I'm not sure where it said 2.5'' but that is not correct. That's all I got out of them. After driving a few days, I measure about 20.5 in the...

Yes if the OME are 11.8 and the stock off the car are 11.3, that's around half an inch taller, and since I am only getting 1 inch of total lift, the OME only have half an inch less squish? That can't be right? Hopefully someone with KK experience and memory or pics can chime in on if they...

Like what the actual **** is the point of this message? Talking down sarcastically over a 1/4 inch in the FRONT when trying to find a whole TWO inches in the back. What is wrong with you? Or should I put more question marks to show superiority ??? Seriously. It doesn't matter what I measured it...

No one is asking about front springs. No one is asking about 4 different springs. I am asking about 2 specific springs. But thank you for chiming in on people who don't know what they are measuring.

Maybe someone who knows what they are talking about can chime in, preferably without elitist sarcasm. Not once did I ask for a lesson on how springs work, I asked why the 731 is giving an inch or less of lift. I swear, internet tough guys love to belittle people in every answer, little jabs...

52109894AE is the stock spring I had on there. Here is the tech sheet. Says 2731 is 300mm (11.8in) and spring rate is 280 while stock is 200, according to this chart.

How can I know if they are the wrong springs beyond the lable?

Well, finally found tech specs, 2731 is only 300mm tall (11.8 inches) which is what my tape measure shows. How can this be when the oem ones are 11.3ish? Is the KK limited a higher spring rate thus a lower amount of new ride height compared to other oem liberty springs?

This is something I found, but its front, and its KJ, but shouldn't the rear springs also be blatantly taller?

.75 inch difference or so

Mislabeled springs? Should the 731 be 2 inches taller than the stock?

This

This

Idk what do you want me to tell you, least valid point of the entire post

Stock oem against the new 731s, barely taller