The walk through
Bennett good find i had just taken photos to help out everyone too.
My infinity's are blown an was replacing them so i shot it.
the front's are 2-Ohm so if you will need to replace the deck an speakers at the same time.
that is y the fronts sound louder than the rears the amps are realy not that great an you would be better off not reusing them.
if you just replace the speakers the volume wont be there it will sound better but the sound is just like in the rear now only 22watts.
they are 3 screw mounting so look for multi install or you will need to drill new holes for most aftermarket speak's
Best thing to do is new deck run to an amp feeding sep's up front and 2way/3way in rears.
You must be registered for see images
armrest screw
You must be registered for see images
handle screw
You must be registered for see images
plastic-pop rivets bout 10
You must be registered for see images
door pull
You must be registered for see images
door lock connector
You must be registered for see images
side mirror connector and door lock arm just push till it unhinges then pull down
You must be registered for see images
3 screws
You must be registered for see images
lift up if you have infinity package cuz of amps
You must be registered for see images
slid connetor lock back then push tab and pull off
You must be registered for see images
nice shot of blown factory paper cone's an foam surround
You must be registered for see images
plus vehicle is black an it's a lil-hot down here in the south
basicly heat rot.
Later for now ..
Ohh i didn't tell you i replace all of them with fosgate goodies P163C in front and reused the factory tweets and a set of them in the rear too.
just ran deck power for now out of the kenwood mp825-mask, yes they are 7" and they will fit.