Search results

Was parked on an incline yesterday during some rain, front was higher than the rear. Got in and started driving homeand qhile going down a hill i had water pour in through the dome light/sunroof control switch. This is on a 2006 liberty, no roof rust, sunroof has been closed for a while with...

As the title states: i have a recurring P0304 code for cylinder 4 misfire. Long story short i have ruled out the following: Vaccuum leaks Pcv valve/leaks Spark plugs Ignition coils Fuel Injectors Throttle position sensor Camshaft position sensor Crankshaft position sensor The...

The tag under the hood says 1.25lb of refrigerant and 240cc of oil. The only component i am replacing is the compressor, i am not flushing the system, the compressor did not fail, the clutch is the problem. But it was cheaper to buy a new compressor. Should i add the full 240cc to the...

Napa sold me sealed power HT-2271 and they are listed as being compatible with the jeep 02-04 3.7L motor. AFAIK, there should be no real difference in the lifters used on the 02-04 3.7 and the lifters i need for the 3.7L in my 2006. Will the HT-2271 Lifters work or will I be in for a...

I need to replace my passenger side rear door, (rust has finally claimed it), I am wondering if a door from a 2003 liberty will work on the 2006 model year, i have all of the trim and interior parts from my 2006 that i could swap over, i am just unsure about the door itself. thanks in advance.

I have a ton of BG Automatic Transmission clean and I am due for transmission fluid and filter replacement. If possible i would like to do the fluid flush myself. I do not have a flush machine, but if I disconnect the return line on the transmission cooler and feed the transmission fluid to...

I am getting ready to once again replace my front door speakers. as well as the wire that runs them as it has developed a short in the transition boot between the door and jamb. I was thinking something like a soundbar in a wrangler or in the plastic trim panel by the driver/passenger's...

Does anyone have experience with the Auto Enginuity ST-06 USB scan tool? I am looking to replace my current scanner with something a bit more capable and adaptable. I have a really outdated OTC unit that i can't do much with on newer vehicles and the "nicer" of the cheap harbor freight...

I brought my newly powdercoated tj moabs and 265/70R16 tires to what is usually regarded as one of the reputable tire shops in my area. And they blew up a tire when they were trying to seat the bead. They started blaming the tires, the wheels, the powdercoat....everything except human error...

i will be replacing the heater core and lines on my 2006 kj in the near future. as most of us already know, this requires dismantling the dash. i am also noticing some noise from the blend door actuator as well as sluggish movement when changing modes (Ex. changing from vents to floor or...

Since i have once again talked myself out of a new truck and into keeping the Jeep, i have decided to add some type of GPS/backup camera/multimedia deck. i am looking at the pioneer AVIC-8201NEX and the Kenwood DNX994S. originally, the pioneer was my go-to, but after reading a lot of...

I found a set of MOAB wheels for the jeep. currently the jeep has a BDS lift with 3/8" clevis lift, 1/4" top plate, and 2 extra isolators in the rear. the wheels on it right now are Pro-comp rock crawler series 98 16"x7" with 4 or 4.5" of backspace IIRC. i am wondering if it would be of to...

i will be replacing the timing cover gaskets and seals (currently leaking oil). i currently have 141,000 miles on the jeep. would it be worth it to replace the timing set while i have it out in the open? a full set seems to go for about $375 on rock auto.

2006 liberty sport 3.7l 4wd automatic long story short: my battery is drained enough to be useless every morning/whenever the jeep sits for more than about 8-10 hours. after performing the ignition off draw test per the fsm these are the results: parasitic draw: about 0.165 amps on the main...

I brought my 2006 sport in to have the tire size reprogrammed a few days ago....the tech botched the job and my speedometer is about 12% slow and my Odometer is reading about 20% less than actual mileage, (based on a gps odometer on a 6.7 mile trip the jeep odometer read 5.5 miles). so I went...

so i am going to be regearing in a few months and would like to install DTT's in both the front and rear differentials. my question is for anyone who is already running either the same or similar setup. have you seen any effect on steering performance after installing the True Trac? please...

I will be replacing my heater core this weekend as well as the heater core lines. Anything else I should look at or replace as preventative maintenance while I have the dash torn apart?

im putting the stock seats back in and cant remember how the wire for the seat belt buckle is supposed to be routed between the seat bottom and the slider frame. so if anyone feels up to posting a picture of the underside of the drivers seat (where the wire passes through that would be very...

let me start by saying that I am aware that the general consensus is that a 15" aluminum wheel will not fit over the brake calipers on a kj. a while back a member on here (wulfhound) got these exact wheels and they fit fine on his KK. so from the looks of it they should fit on a KJ, unless the...

mcgard or gorilla lifetime lugnuts? i know mcgard makes great stuff, but i like the gorilla lifetimes because they are stainless steel. so who here has experience with the 2 brands and can point me to which one might be better?