Well, I changes the Oil to the correct 5W30 and I drove the vehicle for 15 min. Approximately. I did not drive highways so its too early to tell if its fixed yet another issue came up!! The heater hose/tube started leaking coolant at one of the factory hydraulic pressure seals. This is...
Hey! Thanks for the Biotech recommendation, it sounds really good, I’m going to buy it. I‘ll take these steps and call out the results. Thanks again Liberty TC.
RPM’s are at about 700, milage is 140,000 and when I accelerate slightly it turns off. I would love to here possible solutions. For now am thinking that I may have use a couple of my other vehicles oil by mistake (10-w30). I’m going to drain the oil and make sure I add 5-w30 and test the...
Ok, I installed the OEM Oil pressure switch and the oil pressure light still turns on at low RPM’s after a few minutes. I am out of answers right now. Anyone have any ideas? Reminder, the oil pump is new.
I installed the OEM Oil pressure switch and I noticed a big difference between it and the aftermarket. I have not tested the vehicle yet. Will do so tomorrow. Hope it fixed the problem.
OK, it feel comforting to have this forum looking out for us Jeep greenhorns. Having not only member but also moderators pitching in to help a fellow Jeep owner keep his/her ride alive is very much appreciated. Will see whats next.
P.S. I will read the manual to see what the RPM’s are...
Well, finally done with the cooling system work. OEM coolant (HOAT), OEM thermostat, OEM coolant reservoir and purged the bubbles out of the system. Test drove around the neighborhood for 20 minutes and no leaks were detected. Also the Temp gauge reached just below the middle. Then I drove...
I just pressure tested the bottle an it does not hold pressure, coolant just starts Flowing into the overflow chamber. This test was done with The old thermostat. I am having my system flushed today instead of tomorrow and the OEM thermostat installed as well.
Got it. I appreciate the link to the manual that was posted in this thread. I’m having my system flushed monday. I borrowed the pressure test tool from LAPS. Will test now and after the flush with the new thermostat. Can’t thank you guys enough, you are much appreciated.
Water pump is new, radiator is new, heads were repaired, new gasket sets, new timing chain front cover seals, no mixing of coolant and oil (no gel like or creamy gunk)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.