Throwing code P2311
I replaced the spark plugs and coil with no luck. Used a spark tester and nothing. I swapped coils with a working one and the same code. Wondering if there is anything else I could check. Ran fine not to long ago as well.
So this has been on on going issue I've been trying to tackle.
Just some background.
- Heater core has been flushed and they said there is no blockage.
- They deem the thermostat doesn't have to be changed as it gets to operation temperature.
- I've been over heating for a bit found out...
I've noticed now when I get to operating temperature and turn off the engine then turn it back on after a few minutes to where it hasn't cooled down at all it will start super rough.
It will have RPM's and what not but almost seem like it's not fully started and something is stuck it will also...
I know I'm going to get some heat from this question but what does everyone have for an after market muffler. I don't want to spend hundreds I'm looking more for the $50.
Currently it sounds like rocks in a coffee can at the current time and I'm getting tired of it haha.
I was looking into...
I just got this code all of a sudden, Now I did get my rear main seal replaced and went to Dodge to confirm the fluid level.
Now I called Dodge and they said something about wiping the variable counter whatever that means.
Has anyone ran into this before?
So I seem to be having A/C issues, I got a pump and replaced it since the original one kicked the bucket. Got it recharged by the dealer with the correct stuff and pounds.
It was working fine for about a week and a half then just randomly stopped during a trip.
I've replaced the fuse already...
Has anyone used the ironman all country 10ply tires before?
I'm just wondering if they are any good before I buy them. My jeep is stock, no lift and no re-gearing.
So I ran into an issue the other night where my high beams were stuck open. This is a thing since I use an after market HID harness.
Normally I'd hold it in high beam then they'd turn off and I'd have highs and lows again.
Now when I hold high beams they just turn off, and when I put it to...
So I've noticed that I've been losing oil over time and I'm not to sure on where to start looking.
There is oil in the air filter and the PCV was changed out around 258,600KM I'm now at 275,000KM.
I replace my oil every 10,000KM and run full synthetic.
Does anybody have any ideas before I...
I just started to hear this noise in the past few days. I only seem to hear it while in reverse (While idling/rolling) when i give it gas I don't really hear it. Just wondering if this is a normal thing or what the case is.
So my compressor decided to kick the bucket and start leaking and killed the clutch. Still derivable but the smell is horrible and noise is bad.
I'm looking into deleting it for the time being since a new one is about $300 on rock auto.
Has anyone done this before? I'm looking to do it for...
So I'm looking to install a light bar in my grill. I was just wondering whats the size that fits in it and if anyone has any tips of installing it into this location.
I know I'll most likely have to drill holes in the support to blot it in.
Also I'm not looking for a light bar that will break...
Does anyone have a guide to replace the actuator right behind the glove box? I'm wondering if there is an easier way to do it instead if ripping apart the dash and getting frustrated haha.
By the way heat only blows out of the defrost so if anyone knows of anything on this or it's happened to...
So My glass hinge on the left side decided to break when I was on vacation.
As of right now it's held on by adhesive and duct tape, All I could do in a crappy tire parking lot.
Dodge only has the glass that has the hinges attached for $800
I did get the part numbers though.
Left - 5701006AB...
I just have a few questions on what I should do with my Jeep Liberty.
A few things about it:
- 260,000KM/161556Miles
- Full Synthetic oil every 10,000KM/6213Miles
- Changed spark plugs at 246,575KM/153214Miles with Bosch Iridium plugs
- Had transmission fluid, pan and filter replaced at...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.