Search results

Hello What do I need to check? Is defective o2 sensor can cause this faults?

hi guys someone replaced 242J to 231J without any modifications? I'm asking because I read a lot of opinions about it. Some say that it is necessary to change the lengths of the drive shafts or maybe change input on the T.CASE some say it will fit directly, "PLUG AND PLAY" so anyone did it and...

What the hell is this noise?

hi guys.new problem. only at 4low (also if transmission shifter is on P) , the abs pump is braking by itself . if im trying to drive its very hard because its braking all the time. no abs\esp light what do you think? video:

Hi guys,This noise while the car is standing and Im playing left and right with the steering wheel,it’s sound from the steering rack but I’m Not sure what exactly ,anyone’s recognise?

I don’t sure if it is a problem or not ,sometimes I change 2wd to part time ,the dashboard light shows part time but it’s not really there(only rear wheels are spinning),I’m trying 2,3 times to play with the shifter and it’s in,what do you think?

Hi, i have vibration at 100-120kmh I removed the front driveshaft and the vibration is gone! Took the driveshaft to driveshaft's shop and the guy told me that everything is good with it,no play...what else can it be?

Hi guys i need your help I have vibration while driving at 60-75 mph,what can cause it? Another thing, while im driving offroad at 4low only sometimes while turning the wheels i hear knunk(onlt at 4low),what can cause it? And the last thing,while turning the wheel i hear some noise (video attached)

hi guys just want to ask, anybody had issue with installation? I did one side yesterday, was very hard to insert the arm to its pockets! and because the pressure on the bushings its very hard to play with the arm for bolt insert job its should be like this? its should be under pressure? what am...

hi I'm looking for right cv axle inner boot I found this one (picture below) at Napa online but they wrote "Left inner" its not supposed to be the same boot for both sides? also, according to manufacture part number that Napa wrote, its outer cv boot for Volkswagen anyone know if its correct...

hi guys what do you think about the new TrakMotive XTENDED Travel AM8005XTT It's worth it?

Here in israel we dont have napa so we found local axle shop that can repair the movment between the cx axle and axle shaft. What do you think?

Hi guys recently i feel little vibrates/shake (on and off-every few seconds) When i feel this vibrates,i can see the rpm drops to 570-580, what can cause it? I checked plugs,air filter and the vaccum hoses,didnt found anything.

Hi guys Its crazy! I have the same noise since i bought libby 3 years ago 2.5" lifted with 235/70/16 I have knocking noises on holes and sometimes on bumpers coming from the left wheel. I replaced: stabilzer links and bushings,LCA bushings,new bilsteins 4600+shock mounts and also the coil...

hi guys I'm very confused, I want to replace the axle shaft bearing (KJ 2006) my original was the plastic one MOPAR 5066056AB now I found out this is not easy to find this part and everybody goes with the bearing MOPAR 5066056AA there is really difference between them? which is the best...

Hi guys I removed the fan clutch with the 36 wrench and hammer , i need to close it by the same way?

Hi,which one is better for 2.5" lift?

hi I replaced my rear shocks from 58cm open to 63cm open (39 closed) its 5cm longer and now i need to install 2" hockey pucks so if we do some Mathematics, 5cm longer shocks-5cm longer bump stop =0 so in fact the hockey pucks\longer bump stop etc... actually destroy my new longer flex and...

Hi guys My fan clutch is noisy (huming)like an hd fan clutch When i touch the gas pedal Replaced it 2 years ago( mopar) Also The temperature is 90 degrees most of the time What is the problem with it?

hi I found this brands for front strut mounts Monroe kyb any recommendations?