Search results

Hey all, been awhile since posting, the 3.7 KJ is doing well. My wife and I are purchasing a small 2900’- 19’ long (Cherokee Wolf Pup 14cc) trailer and I’m trying to figure out if i have the “aux” trans oil cooler. My trans only has about 20k on it as it was a new install a couple of years ago...

Full set of 4 Spidertrax spacers 1.25" 5 x 4.5. Installed for about 100 miles or so as I decided what route to take with wheels, sizes etc. Complete minus red locktite. Excellent condition. $185.00 shipped. Paypal preferred.

Be awhile since I've posted, but this one has me stumped. 2004 3.7. I've got a bit of a low speed "growl" around 10-20mph. Seems to be from the rear end. I've got Wrangler Dura-trac tires, about 9 months old. OME 1.5 lift. I've had the thing off the ground, no unusual play front or rear, all...

Well, for now, I think my lifting is complete. Went with the "little" OME lift a few months ago, and was pretty happy overall. I had purchased the Rocky Road Outfitters upper strut "trim plates" at the time (more on those later) but néver got them installed as I was hemming and hawing the $ for...

After reading various opinions on coolants etc. I need to know the thoughts on a specific situation. I removed my filler cap and failed to completely lock it down this weekend.(winner) All was well until I hit the four wheel road and it worked its way loose. Spilled about a gallon of coolant...

So, I've got this bit of a surge at 15-1600 rpm and around 40mph. It only seems to occur when the overdrive shifts down. There is very little throttle at this rpm and just wonder what some thoughts may be? I've got new coils, plugs (copper) cleaned TB new TPS. Engine runs well otherwise with...

OME 2948 Rear Springs KJ (reduced) Basically new set of Old Man Emu 2948 (medium) rear springs. Maybe 400 miles on the springs give or take. $115.00 shipped. PP preferred. First sale here, have over 1000 Ebay feedback @ 100%. No idea why the photo won't upload with the correct rotation...

I've done the "basic" OME lift shocks and springs. I did not install the front upper strut spacer however. I wound up with a 2.5" lift total with the front having the same basic chassis attitude as stock (lower nose). Doing this resulted in my pinion/T-case output shaft angle to be out of whack...

Well... looks like I get to change out some u-joints. Rear drive shaft. I've suspected all along, but after a good highway drive and a closer inspection I'm 99% sure they are shot. Front in particular. The questions I have are part number for the Dana Spicer greasable and the crimp clamps. My...

It seems this may be a "tranny characteristic" for Chrysler trannies. When I'm rolling into my garage very slowly at idle (flat) the truck seems to lunge, or slighty lurch a little. Otherwise drives fine, shifts fine, 4wd all works well, the truck will crawl up my (steep) driveway in 4L. This...

04 3.7-119k. Engine seems strong, smooth (relatively) and feels great. The question I have is how do these motors like to be run? Do they like to be pushed, or kind of babied? Just getting a feel for this truck and how it wants to be driven! Can't wait to get it off the pavement!:gr_grin:

Newbie spring/shock install questions... (DONE!) So, technically my second post, and I'm digging right in! Looks to be a great, knowledgeable crowd! Now that I've buttered everyone up, I have a few clarification Q's. I read the FAQ's, did the usual searches and it seems there is a very good...

New to the Jeep thing, have a 2004 KJ and I'm planning so mods! Been through the FAQS and of course, have some questions. Already learned a ton! Looks to be a great forum with lots of good info!