Search results

I was making a move from Ms --> Va last week and the transmission burnt up. I didn't have any issues with the transmission leading up to it, before the trip I checked fluids (including the trans) everything was good. Half way through the trip the transmission started to slip going between gears...

I had to replace my water pump...again, I just replaced it 3 years ago but I digress. When I was removing the pump I pulled the bolts out and when I pulled out one of the bolts it had engine oil on it. (enough to wipe on the ground, not enough that it would drip out the hole) It was one of the...

Recently my gas mileage has plummeted. Today I went 90 miles and hit half a tank of gas. I don't drive aggressively and most my driving is only 5-10 miles at a time most in town, not tons of traffic. It has slowly dropped over the years, I use to get 18-20 city and 22 highway. It has been really...

So I have an 04 Liberty 3.7L V6, bought it in 2012. Since then I have had maybe 5 ignition coils go bad. None of them went bad at the same time, sometimes it would go a year without one going bad. (Also they always tend to do it it cold weather). Well last month the check engine light went on...

I searched through the posts to try to find an answer, even google. I couldn't find a definite answer but found many with a similar problem. I just replaced all my Upper Control arms with JBA uppers and my lower control arms. I have a SkyJacker lift, 2.5-3". I took it to get aligned, got it back...

Hey all, I am replacing my Front Lower/Upper control arms on both sides. Unfortunately on the front left I have had to cut out 3 of the 4 bolts because of rust and who knows. I am trying to find bolts for them, I was planning on buy all new bolts for all of them when I started cutting. After...

I just had my trans rebuilt due to it just becoming total crap. Also while I was in there I had my differentials regeared to 4.11 from the stock 3.73. Right now I have 265/75r16's on there and I am looking at maybe dropping down a little. I was looking to buy new rims because mine look like...

I am not sure if this is where I should post this but I needed to vent and wanted to share my experience with CarID. I went online and found Catalytic Converters (passenger/driver) Magnaflow direct fit. The website said it was in stock and would be shipped in a couple days. I ordered the...

I am not sure if this is where I should post this but I needed to vent and wanted to share my experience with CarID. I went online and found Catalytic Converters (passenger/driver) Magnaflow direct fit. The website said it was in stock and would be shipped in a couple days. I ordered the...

Hey all, I need to replace my front drive shaft. I am having problems finding out which part I need. when I was at autozone they said it came in 3 different sizes. 16.5"/19"/20" measured from weld to weld when collapsed. But when I called the dealer to try and find out they could only give me a...

So I thought I would see what you all think and/or have done. My catalytic converters are shot on my Liberty. Also other parts of my muffler are rusting through and need to be replaced sooner than later. I figure if I'm going to pull things apart to replace the Cat's then I might as well replace...

Hey all I just put a SkyJacker lift on my 04 Liberty. Kit number was Lib250K-N, it was the middle priced of the three kits that came with suspension components. Overall I am very satisfied with the ease of installation and the instructions that came with it. SkyJacker included 8 page...

So I reset the check engine light at Auto Zone then went to get it inspected (NYS) and he said it failed because the code I reset needed time to be rechecked by the computer. I can't find how many cycles it takes to reset and what exactly a cycle would consist of. Thanks!!!

Hello all, I'm Karl. I have an 04 Jeep Liberty 3.6L 4x4. I've owned it for 3 years. Original owner was from NY so everything and anything that could rust has rusted. I recently decided to add some testosterone to it. 2.5" lift, 2" wheel spacers and 265/75R16. Had to take the fender flares off...