Search results

This is a used, serviceable shaft. Built with 2" tubing and Spicer Solid Cross U-Joints. Has a grease fitting as well. Needs new u joints. Msrp is $340.00 Asking $150.00 + shipping

Parting out the 03 Renegade... No engine in the truck... But everything else in terms of the driveline is still there... So far all the skids, tow hooks, fender flares, rear glass, interior driver side 1/4 panel and shifter are Spoken for... Everything else is available. I'll pull any part...

https://vimeo.com/117605051

Got myself a 03 renegade complete minus the engine... lol... Original plan was to cut it up and use it to totally finish Lucy and Lucy II... But it's so damn clean... Has no rust... Is basically immaculate on the exterior... And also has an immaculate history report... So now I'm thinking I...

Anyone have a ypipe for an 02 kj laying around? I don't need the cat, you could cut it off and scrap it... I've got a magnaflow to weld on... Also need the pre Cat on the passenger side! Lemme know whatcha got!

Just what the title says... Let me know!

https://vimeo.com/109379742

SHE LIVES!!! Runs nice and smooth.. No hiccups whatsoever... The only reason it sounds so loud is because they cut out the high flow cat... And the only code she's throwing is for a throttle position sensor :) soooooooo now I really don't know what to do !!https://vimeo.com/107426548

Hey guys quick q... Can't I technically try to start the recovered jeep minus the power steering pump... Using the shorter ac bypass belt that I have? It fits pretty snug and is routed "correctly"... I know it's probably not an option until I replace the brake master cylinder... Just because...

If you do can I borrow it? I'll send it right back :)

I'll post pics tomorrow... But a quick once over and I can see that they stole the complete left front caliper, the left front rim and tire, the brake master cylinder, the power steering pump, they cut the hard lines up and stole the ac condenser, radiator fan and shroud, they cut the high flow...

So as you guys know they found my truck all beat up and battered last week... She was stolen on the Fourth of July.. Anyways I'm trying to reach out to the jeep community to see if anyone has a set of scrap rims/tires that can go to jeep heaven with my poor Lucy... My insurance company is going...

Its been over a week and I must say that hands down this has been the best "performance" modification yet... You have to go to the dealer and have them input the correct revolutions per mile figure into your computer. Once done your truck will "wake the heck up" and act like it did the day you...

Bought these but no longer need them thanks to DRACO! I paid 75 a piece for em plus shipping. So say $140.00 shipped obo... Trying to get some funds up to install everything I bought :)

And swap out my water pump... Can I drain the petcock and reservoir... Fill with distilled water and let it run until the fan kicks on (water pump activation) Then drain the petcock, and repeat the process until its clear and then start filling with G5??

So I knew about this when I went to get the truck but it totally slipped my mind... Look at the awesome custom front drive shaft she came with :) oh... and just installed moog rack and pinion bushings, and stabilizer links and bushings :)

And now it won't disengage even when off... The clutch just keeps spinning and spitting out cold air... Can I drive to work and home like this with the ac on low and troubleshoot the shims tomorrow? Or should I reinstall the shorter belt and bypass it in the meantime??

If anyone has anything laying around that they don't need ... Please let me know what you have... I need a set of jeepinbyal arms for a lifted libby, any kind of lift components, etc... Thanks in advance!!

I hope to know by the end of the day!!