Search results

So I finally got my lift and rock rails put on this weekend and I'm itching to try it out. Anyone planning to go to Uwharrie or Gulches (in the carolina's) on memorial day weekend? Sent from my PC36100 using Tapatalk

Been trying to install my frankenlift and I finally got the first corner almost put back together.but I cannot tighten the but on the upper arm, the ball just spins. Any ideas on how to get it to tighten? I have tried using 2 ratchet straps and a pry bar to apply downward force and it still...

So just got done installing my new drive shaft cv joint. Drove around a few blocks got up to about 30 everything seemed fine, crawled under to check it out. The cv seemed a bit hot got that short of a drive. Not too hot to touch but too hot to hold my hand there comfortably. Is this normal...

may be a little early to ask but, anybody planning anything for memorial day weekend? Either Uwharrie or Gulches, i think those are the only ones that are fairly close by ( still 4 or 3 hour drives from charleston) think i should be able to get my lift and everything installed by then and...

Just out of curiosity, and i dunno if this answer is already posted or not. for those of you who have ordered a Frankenlift, what was your average wait time to receive the product? Shipped the day, or day after you ordered it with 3-5 days transit? or did it take a week or two for it to get...

so as i was trying to extend my breather tubes today i found this... http://img861.imageshack.us/i/img20110416123541.jpg/ http://img718.imageshack.us/i/img20110416123557.jpg/ the boot on the front driveshaft, up against the transfer case, has a nice tear in it... I have dont a little bit...

so i was bored and decided to extend all my breathers while i had a chance. got the rear axle done, and found the transfer case one, but cannot see to find the Transmission one... i have the NV3550 manual transmission, feeling around the top of it i felt something that felt kind of like a thin...

Ok so I have been trying to find a set of skid out of a local junk yard but no one seems to have any 02- 07 liberty's. But one place has an 08 and a 09 kk, are the skids (engine and transmission) compatible our close enough at least for my 03? Sent from my PC36100 using Tapatalk

Hey whats up, new to the forum, had my liberty for ~3 years now. Planning on lifting it in about a month or two, looking for some people close by to start wheeling with :) Jeep Liberty Renegade, 2003 Silver, Manual transmission