Added a couple of items,in the selling mood. Tired of looking at this stuff and hate to send for scrap/trash. PM get noticed quicker than...
The nicks are the problem,possibly the bearing is worn some also. Half ass fixes get half ass results.
Was reading as the nicks where on the...
Where do yall think Mopar radiators are made?
Just because;when I did my muffler replacement could tell that some low end was lost. Libby needed to be wound a little more in order to hold...
I cut the stock muffler out and replaced it with a Thrush glaspak,had to use a little piece of pipe cause I miss measured,otherwise it went right...
Keep driving 120-140kph on rough roads.
Well worth paying someone to do springs if you are going to swap/change them. The monroes are a good choice to just R/R stock.
All you need is a CV.
Crown Vic on Hell's Revenge- Moab, Utah - YouTube
Paypal as gift [email protected] Or a good check/money order. PM gets my attention more than posting. Just saw your post on LOST.
Cut the top off. Build a cage. Wheel the piss out of it. Oh,and pics are needed of the fun you had.
Would bet on "O" ring on pressure line.
As best that I recall the stops for the front fit into a notch type place. No need to drill.
This place has CV's for both ends of the front shaft.
ME709: Driveshaft Parts
If they will not ship to you I would be willing to get the kits and...
See post #1
New one can be had for $80,would not consider a used one myself.
Someone buy this.
I Used 2x2x1/4 tube to slide in to "frame" and stick welded them. Then added another piece of tube on top of them to raise mounting plate height....
Separate names with a comma.