A couple I googled https://www.morris4x4center.com/np-231-transfer-case-parts.html...
yes top left in the pic.
If you are tying to run wires,just run them through the main harness grommet.
That's how I ran wires.
Here is a link to some Moab replicas in Canada- https://www.tdotperformance.ca/mamba-mr1x-series-wheels.html
Just above the drivers side kick panel (where hood release is) where the main harness comes through the fire wall is where I ran some wires.
I got ball studs for my 06 here- http://lstechnologies.ca/
SW7M5 is the size I used.search in mounts and brackets.
The rear cv is the one that usually goes when the boot fails.
Link to rear cv rebuilt kit-...
Are we talking front,rear or both.
Are you using wheel spacers,oversize tires,are you lifted,do you have the proper bumpstops?
Front and rear stud spacing on the upper mount is the difference.
It should be located just behind the alternator,screws vertically into engine block.
looks like this...
KL Cherokee transmission recall .
Bring a gas can,there are some good stretches with no services.
I always take hiway 11(northern TC route from North Bay)it's straighter and...
I have run both.
If you run mostly empty 926,if you run with a load 927.
Even a light load will smooth out the ride of the either.
See here: https://www.jeepkj.com/threads/blower-motor-resistor-upgrade-for-kj.65152/
Mine is the same, about 1/2in of thread showing.
I got a large socket to do mine,eezy peezy.
Don't have alot kms on them yet,but seems a little more peppy at take off and rpm is a little lower at 80kph OD off.
And the speedo seems a little...
Try searching hex rivnut.
5 new KO2's on the 07.
Switched from 245/75/16 to 255/70/16.
07 rolled over 100,000kms.
8 years to put 40,000kms on it,(had 59,000kms when I got it)mostly off road.:)
Separate names with a comma.