AnotherPassword
New Member
2003 Liberty Sport 3.7L 4x4.
I have been troubleshooting airbag light staying on. Checked clockspring, front sensors, etc, all seem ok. Does the Airbag control module check the seatbelt status as part of it's checks? On the driver side I know that would be the seat belt latch, does it check the pyro device that locks the drives side seatbelt too?
I got the diagram for wiring to the Airbag Control module, it shows seat belt wires going to it, so I am assuming it checks at least the latch.
Strange thing is, whether I have the driver's side seat belt latched or not, with the latch wiring harness connected or disconnected, and am driving or not, the seatbelt light ALWAYS goes out. No chimes either.
Am wondering if this may indicate a bad module or a wiring issue? :emotions34:
thanks,
ds
I have been troubleshooting airbag light staying on. Checked clockspring, front sensors, etc, all seem ok. Does the Airbag control module check the seatbelt status as part of it's checks? On the driver side I know that would be the seat belt latch, does it check the pyro device that locks the drives side seatbelt too?
I got the diagram for wiring to the Airbag Control module, it shows seat belt wires going to it, so I am assuming it checks at least the latch.
Strange thing is, whether I have the driver's side seat belt latched or not, with the latch wiring harness connected or disconnected, and am driving or not, the seatbelt light ALWAYS goes out. No chimes either.
Am wondering if this may indicate a bad module or a wiring issue? :emotions34:
thanks,
ds