Aceofspades
Full Access Member
Interesting ..... the black looks good with your paint.
Guess that's gonna be my next project
What did you do to your jeep today?
- Thread starter TheQ
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Interesting ..... the black looks good with your paint.
Guess that's gonna be my next project
Aceofspades
Full Access Member
Ok I did it - what do ya think?
You must be registered for see images
Aceofspades
Full Access Member
Thanks ! Glad I took the plasti-dip plunge
O5berylgrnrenegade
Full Access Member
Changed the starter out and ugh looks like its starting to develop a head gasket leak
Jim McClain
Full Access Member
Drove a mile to the grocery store and worried the whole way that the serpentine belt or the A/C pulley would break - such a racket. Yesterday the A/C pump and clutch arrived, along with a new belt and accumulator/dryer. Just waiting on the metal hose so I can make the appointment to have the repair done.
uss2defiant
Full Access Member
Jim: just a precautionary note, aftermarket low side orifice line is known to not have the correct length such that it is not flushed on the P/S side, right above the wheel well) of the engine bay. I had to zip tie it to pull it down wards so it cleared the pneumatic hood strut.
If you haven't done the belt tensioner yet, I'd get one of those too. Locally you should be able to get Dayco or Gates, either is fine. Gates comes with a new bolt, Dayco one doesn't.
dude1116
Full Access Member
I wheeled it. No really good pictures...but we hung out by a lake in the middle of the woods where all you could hear were the bull frogs. Absolutely awesome.
You must be registered for see images attach
Last edited:
wheeee32
Full Access Member
Washed the exterior/interior. She sits in the parking lot now while I'm stuck on watch.:buffer:
turblediesel
memberable
Glad you're healing and getting around. Isn't that a huge traffic jam at the Bay bridge on a friday?
Just installed the PML Transmission Pan!
Unfortunatelly, i haven't ordered it with the Temperature Sensor Machining option, as i thought i could obtain this info without gauge, through the OBD. However i haven't had luck with that so far with Torque...
Unfortunatelly, i haven't ordered it with the Temperature Sensor Machining option, as i thought i could obtain this info without gauge, through the OBD. However i haven't had luck with that so far with Torque...
You must be registered for see images
Jim McClain
Full Access Member
Thanks for the info. Wish I had known that before ordering after market.
Dang, I almost ordered one of those too, but no one mentioned it in my topic about this A/C problem.
I'll check Napa, but they are pretty expensive here.You can't share photos from your computer like that. Use the upload feature, or use those IMG tags to surround an image address on the Internet (not Photobucket or any of those "free" image hosts). Like this:
[noparse]
You must be registered for see images
[/noparse]Which will display like this:
You must be registered for see images
And when you save pictures, don't use spaces in them. Use dashes or underscores, but not spaces or other characters.
Yep Mine is back again after 6 months it was fine. I had them tested 1/2 dozen times. If you ever figure it out give me a holler [emoji38]
Sent from my KFDOWI using Tapatalk
Similar threads
