Been absent from the site for a bit. One of the topics I had been following was the "front rcvr hitch" thread. I put my project on hiatus till this past week. I had all the parts cut sometime back, then just sat them on the shelf. Got a wild hair going and got it finished and hung.
I went the double route. Only had to open up the factory exit areas and trim the lower air dam to clear the hanger brackets. There are some heavy duty nut plates inside the frame rails. Using the original two forward mount points and an other point 8 inches further back. The frame rail is sandwiched between the hangers and nut plates. The cross tube goes thru the rcvr tubes and the hangers. I opted for the no "butt-weld" assembly. Pure overkill by my buddies declaration.
some pics to follow shortly
I went the double route. Only had to open up the factory exit areas and trim the lower air dam to clear the hanger brackets. There are some heavy duty nut plates inside the frame rails. Using the original two forward mount points and an other point 8 inches further back. The frame rail is sandwiched between the hangers and nut plates. The cross tube goes thru the rcvr tubes and the hangers. I opted for the no "butt-weld" assembly. Pure overkill by my buddies declaration.
some pics to follow shortly