02 sensor replacement help!!

I got a p0137 and p0138 so i got a new after cat 02 sensor and am in the process of replacing it but i cannot get the electrical connector to disconnect!!
Anything i can do to that to come off??

Mine was a pain in the **** also. There is a little clip that holds them together, squeeze and pull brother

OHIO04KJ said:

Mine was a pain in the **** also. There is a little clip that holds them together, squeeze and pull brother

Click to expand...

i tried i even got a set of mini channel locks up there to help and i still cant get that sucker out!!!

I know, I thought I was gonna rip the wires out....

OHIO04KJ said:

I know, I thought I was gonna rip the wires out....

Click to expand...

well F!@^ i just did rip the wires out....
now what???

Not sure! Is there enough left to splice it back together?

BTW, did it come apart easy now that your holding it?

OHIO04KJ said:

Not sure! Is there enough left to splice it back together?

BTW, did it come apart easy now that your holding it?

Click to expand...

now that im holding it i still can't get it apart!
three pins came out of the harness so i could i get those 3 back in and i broke one pin...
so there maybe a chance of saving it, but im getting a wiring diagram for the 02 sensors printed out from my dads buddy at the dealership so we shall see what we can do with it....

There is a universal 02 sensor made to splice in the harness.

Good luck!!!!!!

ridenby said:

There is a universal 02 sensor made to splice in the harness.

Click to expand...

Well my main issue is the wires coming out of the main harness aren't marked and 2 are identical black... im going to try to reuse the connector and shove the pins back in the harness and see if that works.

Alright i got the pins sodered back on the connector back on and drove it to work (only about 2 miles) and seemed to run normal, i still haven't gotten to reset it but i will when i get home tonight!