Recent content by wheeee32
-
4.10 Re-gearing - 2025
Front diff definitely has to come out to swap the new gears in. It will feel like a new vehicle once you regear. Mine felt stronger and smoother when I accelerated. Fuel economy went back to stock numbers as well.- wheeee32
- Post #6
- Forum: KJ General Discussion
-
2006 Fog Light replacement
I was guessing so. Just wanted to confirm my suspicions. I could make them work but currently don't have the time to devote to modifying.- wheeee32
- Post #3
- Forum: KJ General Discussion
-
2006 Fog Light replacement
I have a 2006 65th edition. I saw these and I'm curious if they will work or...- wheeee32
- Thread
- Replies: 2
- Forum: KJ General Discussion
-
*UPDATED*Weird Front Turn Signal Shenanigans
Found it! Cleaned up the chassis ground behind the drivers side lights. Running lights and turn signal blinking works again. So glad the schematic was posted online. Made finding that ground a lot easier.- wheeee32
- Post #5
- Forum: KJ General Discussion
-
*UPDATED*Weird Front Turn Signal Shenanigans
Okay I see on 8W-52-5 and -6 of the schematic the ground for both. Looks like it might be close to the right fog light. https://www.colorado4wheel.com/manuals/Jeep/KJ/2006-KJ-SM.pdf- wheeee32
- Post #4
- Forum: KJ General Discussion
-
*UPDATED*Weird Front Turn Signal Shenanigans
Yeah based off the weirdness of it I was thinking ground before I even started looking for the wiring diagram. I’ll reply back once I find the bad actor.- wheeee32
- Post #3
- Forum: KJ General Discussion
-
*UPDATED*Weird Front Turn Signal Shenanigans
Okay so initially this started with the passenger turn signal giving the quick flash. I changed the bulb. Same issue remains. I notice that the drivers side parking light doesn’t come on but the turn signal side works just fine. The passenger side parking light doesn’t comes on. I tried the...- wheeee32
- Thread
- Replies: 5
- Forum: KJ General Discussion
-
What did you do to your jeep today?
Ordered the GM filler neck part. When I get the headliner redone I'll have this done so I won't have the fuel burp issue anymore. I want this issue gone before the Jeep gets repainted.- wheeee32
- Post #26,307
- Forum: KJ General Discussion
-
What did you do to your jeep today?
How do they look now? Bright enough? I'd be down to install these compared to the stock ones I have now.- wheeee32
- Post #26,306
- Forum: KJ General Discussion
-
Actual downsides to spacer lift
OME and the other higher cost options are usually recommended due to less headaches popping up after installation. I did mine back in 2014 and have only replaced common wear items since and the ride has been nice. My alignment has also never needed much correction anytime I take it for an...- wheeee32
- Post #13
- Forum: Lift Kit Discussion
-
Ball jointed sway bar links
Installed the Tein links on mine two days ago. Good so far. I torqued everything after driving around the block. Eliminated some of the noise I'm having on the front end. Still have another clunk on bumps and a creaking noise when turning while barely moving or backing up. I'll get that...- wheeee32
- Post #28
- Forum: KJ General Discussion
-
Front Washer Nozzles Conundrum
Fixed it. Lines were backwards. Good to go now.- wheeee32
- Post #4
- Forum: KJ General Discussion
-
Front Washer Nozzles Conundrum
I'll go back and look. It's possible.- wheeee32
- Post #3
- Forum: KJ General Discussion
-
Ball jointed sway bar links
Just ordered a set. Will give feedback after I receive them and do the install.- wheeee32
- Post #9
- Forum: KJ General Discussion
-
Front Washer Nozzles Conundrum
Recently replaced my windshield washer reservoir on my 2006 Anniv. Editon. The part I replaced it with had the sensor and pump included. Went to op check after install and now the front nozzles only come on when you use the spray function for the rear wiper and the rear wiper swipes. When you...- wheeee32
- Thread
- Replies: 4
- Forum: KJ General Discussion
