Recent content by 03 KJ Gal

Thank you!!!! What a relief. I was beginning to think I’d never be able to do this myself. A million thanks!!!

This info is more than adequate for after the install and I appreciate it. I had no idea it involved so much. I just don’t know how to PHYSICALLY remove this thing. I have no clue what’s even holding it on besides one bolt I see in the center. Don’t think it’s that tho

Hey I ended up having a bad TCM. I purchased a plug and play but have no idea how to remove the old one. I can’t find any videos for this. Any idea?

I have an 03 liberty sport 4wd 3.7 I have a plug and play TCM that has been programmed to my vin number. I’ve looked for hours trying to find a video or someone who knows how to take this thing off. PLEASE HELP

Situation- 03 liberty sport 4wd 3.7- Every morning I’m in limp mode. Code 0605 and 0700. I can sometimes clear the engine light and will be able to drive for the day. Other times I have to do a TCM reset by holding the gas pedal down 15 seconds with key turned. If I do that and then clear the...

Yep my U-joint is bad. Also have a broken motor mount

Oh wow. That’s pretty simple. Thank you SO much for all your help! I’ll check that out tomorrow.. if we ain’t flooding again lol

Sounds better. So how would I know if it’s too far gone? Will I see the grooves and teeth worn?

Wow that sounds bad. Is the u-joint replaceable or do I have to replace the whole driveshaft

Thanks so much. I’ll definitely check into the recall

Can someone please guide me as to where the heck the motor mounts are on an 03 KJ.. I’ve searched everywhere and no clear answers. Also would a broken motor mount cause a clanking noise in the rear at acceleration. Thanks in advance

Great thanks! I’ll have that done

Ok thanks! I’ll give it a try. My Jeep has ran a lil warm a few times, should I change the thermostat

Ok I see the relay mounted on the side. What’s that called?