Recent content by vibit

Hello i have a KJ 2006 Renegade Manual 6-speeds with about 200k Miles and am having a dificult in idle acelerations i can press the pedal and the truck respond about 1.5 2 segs laters, the throtle body is wired not electrical and is really anoying to drive like that. When am at 900rpm+ i can...

Hello again, i finally fixed the AC problem, i was taking down the Pull of the compresor (without takin down the compresor to not lose the gas) and i broke the high presure hose and lose the gas, i take down the hose to repair, that hose come with the AC traducer sensor, thats tells the PCM the...

Thx again for the quick reply as i told you in the weeken i will put down my tank and hope is a bad wire or something like that adn resorder the PCM pins too, i keed you informet because maybe it-s helps aonther user

Yes in the FSM it says that the volt on full have to be 0.2 if i remember and in empty 8.5v i tested the ground on the conector below the rear pass seat, under the carpet and the ground work and the 12v work too, is a continued 12v. even with the key on off. soo the BCM is sending the signal...

I will try this the weeken too, the borring part is puthing down the fuel tank, my KJ donent have a tray on the back soo everutime i want ot check somthing ins the tank i have to take it down xD i will check the wire in that site, because some time ago i was having problem with the ABS and...

Thx for the quick anwers. Using the FSM i checked the Low Oil Presure swithc and is working fine, the swuitch is in the condesator (i thinks thats the name os the little can under the water reservoir) that what i user to start my AC. 1 wire of the swithc to the interior AC switch and the...

the only thin i can test now is try to disconect and reconect all the conection you say to see if a bad or improper conection fix the problem for the U1411, for the P0645 i dont know what else i can do because as i told you i put a direct wire from c3/11 to 85 and nothing happent

Second anwers. When i bough the Truck the owner say that the gas wont show off because bad fuel level sensor and have to be replaced. I bough a new Mopar fuel pump/case (about 250$) put down my gas tank change the pump/case conect everithung start the engine, clean the DTC and 5 min later...

I live in venezuela so sorry if my english is not the best :D Anwering in order I already tested the cable route and even cut the c3-11 pin/wire and put a wire directly to the 85 in the relay, start the engine put ac on and nothing happen, no ground coming from the pin, the way i have to...

Hello i bough a used 2006 Liberty KJ Renegade, motor and transmition are fine but i get this 2 DTC codes and cant clean them, i have de FSM look both code and do all the test it's says but both say in the last test "replace PCM" i cant get my AC work (P0645) and cant see my remainin fuel...