tommudd's latest activity
-
tommudd replied to the thread What did you do to your jeep today?.MOPAR thermostat I hope -
tommudd replied to the thread this has not been a good day for me- broken JBA UCA.Back in the days of Al Handy ( the original JEEPIN BY AL ) yes , and the very early JBA arms I had two sets of those Then Marlin took...
-
tommudd reacted to blackhawk's post in the thread this has not been a good day for me- broken JBA UCA with
Like.
I love jba uca. Marlin is a very proactive person! -
tommudd replied to the thread What did you do to your jeep today?.No longer sway bar links are needed , I ran over 4.5 inches for way over 100,000 miles with stock length links and no issues at all...
-
tommudd replied to the thread 2012 KK Lift Medium Springs for Rear.There NEVER was a Heavy Duty rear spring from OME for the KJ or KK Not sure what you had but only mediums and light duty for the KK...
-
tommudd replied to the thread What did you do to your jeep today?.On the front , just loosen clevis bolt, using the end of a 3/8 inch extension, raise that amount and tighten down and done
-
information regarding this can be found here: JBA strut spacer or clevis spacer? as far as I can see, JBA does no longer sell clevis...
-
tommudd replied to the thread What did you do to your jeep today?.should only of been one end
-
tommudd reacted to mercdudecbr600's post in the thread Buyers Remorse Open Country - 245 75 r16 with Like.
245's actually look a little too small for the 8" width wheel. 245's on the other hand look perfect on the 7" width wheel. I'll send pic...
-
tommudd replied to the thread 245/75/r16 vs 235/75/r16.thinner. wider, not enough to really notice I ran 265 to 16s and 265 75 15s and got the same mileage as one with 235 70 16s
-
tommudd replied to the thread 245/75/r16 vs 235/75/r16.below
-
tommudd replied to the thread 245/75/r16 vs 235/75/r16.ny wheel spacer sits the wheel/tire combo out further which in turn will cut the radious of how much you can turn
-
tommudd replied to the thread Bilstein 33-185552 Shocks Sleeves.DO NOT BUY THE 5100S Anyone thinking or wanting to use the Bilstein 5100 adjustable front shocks , think again If you do want to use...
-
tommudd replied to the thread Bilstein 33-185552 Shocks Sleeves.Yes the sleeves go in one end of the bushing
-
tommudd replied to the thread Front receiver hitch.Stand back That is what almost to the word 3 of the folks said before their KJ they were winching up over different hills said before...
