Recent content by Steven Rolfe

  1. S

    WITECH VCI POD Diagnostic Tool V13.03.38

    Has anyone used the WITECH VCI POD Diagnostic Tool V13.03.38 with the DRB III emulator software ? my old Jeep Cherokee 2003 won't talk properly to my icarsoft scanner... it connects and has reset a few things ABS warning light, but won't read codes or detect the dreaded engine warning...
  2. S

    Power loss .. turbo ?

    Now this is getting weird...... Drove 30 miles, did a tight left and right turn off of a motorway to get to a service station to get some diesel ( my car is UK version but I am driving on the Right in Switzerland) It was performing totally fine... back on the motorway again doing a few tight...
  3. S

    Power loss .. turbo ?

    Okay thanks.... the noise seems to be though not from around the turbo but the EGR actuator... its like its hyperventilating lol Yesterday I also put the remaining new hub on the front as well as a new disk and pads.. I did the other side last weekend.. a few pics.. 5 bolts to take off , 5...
  4. S

    Power loss .. turbo ?

    So the old Jeep seems to back to normal (so much for it needing a new TURBO) now after giving the MAP a total clean... it was super clogged up.... I did have a look at the EGR solenoid, popped the two top pipes off and there was plenty of suck from one of the pipes. There are only two pins to...
  5. S

    Power loss .. turbo ?

    Did the 4 key turns... heypresto.... all the codes appear .... I didn't have a pen in the car but there were 5 different codes and I will write them down tomorrow and see what they are.. Thanks again..... Regards Steve
  6. S

    Power loss .. turbo ?

    Ju I sent a moaning Email to the Jeep garage, they now admit the Turbo itself is OK, the error message appears that the problem is an excessive inlet pressure. The turbine as well as the compressor are working well. However, the problem is the Wastegate regulation. Of course Jeep tell me this...
  7. S

    Power loss .. turbo ?

    the strd
  8. S

    Power loss .. turbo ?

    than Thanks very much indeed, I will take a look to see if I have the vane actuator... there is certainly a little pipe coming off from the Turbo , not sure where it goes though... Regards Steve
  9. S

    Power loss .. turbo ?

    Thanks very much indeed for your help, i really appreciate your response and links... the Jeep is a UK model, but I brought it over to Switzerland with me where I now work, the Swiss Jeep dealer quoted 4500 chf to swap out the turbo, even they said it was expensive, considering I paid 1800£ for...
  10. S

    Hub replacement

    Just doing today the same Job in parallel to worrying about the turbo.. all the bolts span off my 2003 CRD easy but I was using the mother of all Milwaukee M18 impact wrenches.. I will clean up the rust off the recess where the new hub sits in and put a smear of anti seize marine stuff in to...
  11. S

    Power loss .. turbo ?

    Dear all.. my normally trusted jeep 2.8 CRD limited, 2003 is playing up.. MIL light is on but my two code readers and my local garage show No codes.. took to a Jeep dealer and they told me that the turbo had failed.. so yesterday I removed the air box and a few other bits and pieces to get to...
  12. S

    Hub replacement

    WHY CANT I SEE THE PICTURES PROPERLY ?

Latest posts

Members online

No members online now.
Top