Seems the modules are programed by the vehicle they were initially in. I had one from a two door. All it showed was a passenger door open when the rear doors or rf door was open.
The 5601 I installed shows everything by itself. I wonder if it will show the hood?
One of the easiest mods to do. Even easier since I chased extra wires down the pillar wheni did the evic mod.
Really like this one, just wish the outside mirrors could auto dim also.
just for knowledge sake here.
At least on the 06 there are only two clock springs available and they are both 10 ckt. So its plug and play with the switches. Early GC switches will not work. May look the same, but mount differently. Same goes for the CC switches, look the same but...... are 2...
The one up front was easy.
The back one was trickier.
Really, both were easy to do. Both were pulled from the salvage yard with a pigtail to match. The front one simply took a drilled hole the proper size for the outlet to snap in. I cut this one kinda close due to the duct in the console...
'04,'05,'06 not sure on the '07 and up. That being said you will need the evic from a Libby from those three years. One from the Libby will also show the proper door open messages.
part # 56010520AD or 56010527AD from the '05-'06
or
part # 56010437AA or 56010438AB from the '04
I currently...
caution old thread revival alert
I finally got this little job done with my '06 Sport. Glad it is complete.
Just a couple notes about the '06. Be aware that a steering wheel from an '04 is not compatible physically or electrically. By that I mean the wheel('04) itself is not compatible with...
Mr. V
Thanks for the idea on the rear foot well lighting. Just finished wiring them in last night. Another useful mod completed.
Also added two extra power outlets to the interior. First one is in the console up front and faces the passenger door. The second is under the drivers seat at the...
One could read thru all this and still not have the correct answer to the resonators purpose.
One of the BIG reasons for it is to help pass the noise test parameters. Wanna do some informed reading? Study up on the early Buell air boxes. That would be Buell motorcycles circa pre 2003 models...
Stingn,
so what is / is not working now.
"No Bus" means it is not talking to the BCM. Could be a couple things with this. Bad OTIS or the wrong one. Did not connect to the PCI bus....
The temp I cannot help with.
If you are talking about the overhead lights. Did you swap a wire in the...
by simply putting a ground on pin 19? and the light turns on. You didn't hurt anything then. To make it work with the flip of a switch. That is turn the aux lights on and the indicator light. Either use a DPST(double pole/single throw) switch. One pair of contacts to power a relay for the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.