Recent content by Niloc

Thanks I will give them a try

Hi all is anyone aware of a company in the uk that is able to test a cherokee kk ecm unit. i am still chasing the crank but no start problem and we have tested all that we can think of and running out of options. One of the few options remaining is an issue with th3 ecm that is preventing...

To be fair to the garage it was my decision to replace the pump based on the cost of having the pump tested by a company to supply a fully reconditioned unit . The garage suggested that the pump may be faulty due to the low rail pressure . He may have already performed leak tests which led him...

Hi He may have done them I will check with him

Hiya I did get a replacement valve but we didn't fif it yet. I will pass on the suggestion for a pressure leak test as well hopefully something will work. Thank you for the suggestions Colin

Hi I thought it may be but just wanted to make sure. The pump was removed because the pressure was low at the rails. I was going to get it checked but in the end the testing cost was nearly the price of a refurbed one from a local place so just replaced it .

Hi Sorry being a bit thick here what is cp3? Colin

Hiya I know it's not right should be 2900 I think to work the injectors for starting. The hp fuel pump is a reconditioned new unit and there are no visible leaks. I am wondering if the pump is not being asked to provide the right pressure to the rails because the computer doesn't want to start...

Thank you for taking the time to reply and we have covered all the steps your mentioned . There is 3/4 of a tank of fuel Cam sensor was replaced as well as crank sensor but both the old units tested good. Glow plugs are good and getting signal on start. The garage has replaced fuel pump and...

Hi Still got a problem with my 2.8crd kk cranking but not starting. Initially had crankshaft sensor code but replaced and no difference so tested the existing one and it was fine. I had the fuel pump checked the wiring checked and the timing checked but no problems with any of those. My next...

Thanks for reply Is it right behind down pipe or slightly foreward or rear of.

Hi I think i am being a complete numpty but i cannot find where this crankshaft sensor is. My vehicle is a jeep liberty (cherokee in uk) 2.8 crd ltd 2009 model . i know the crankshaft sensor part number is 68029496AA and the pics i have seen for it does not have an oil seal washer on. The first...

Hi everyone still on the same subject I am really struggling to find the correct crankshaft sensor. I think the part number is 680294AA . Can someone please confirm this sensor should have an oil seal ring on it as the sensor I received did not . I am very confused at the moment as you search...

Hi one more question now I have a good idea where to look. Is the sensor better accessible from underneath the car as I have a good set of ramps I can use or is accesing it from the top the best way thanks again

Thanks for info the breakdown had all the kit for testing and told me it was the crankshaft sensor gone faulty but I will confirm that before I dive into the engine bay