lfhoward's latest activity
-
lfhoward replied to the thread 2008 Jeep Liberty Distribution Box Question.I've replaced the distribution box in my Jeep before. That white plastic is part of the hinge that opens and closes the main mode door... -
lfhoward replied to the thread What did you do to your jeep today?.That makes sense. Mine must have air in it. Low side static pressure was about 40 psi (once I tried to charge it), but goes to 0 when...
-
lfhoward replied to the thread What did you do to your jeep today?.The gauge at zero when the compressor engages is what mine is doing. I would be interested to hear what the problem is once you figure...
-
lfhoward replied to the thread What did you do to your jeep today?.I haven’t heard of anyone using them either. But I have stock CV’s and never had any issues. I have heard of people having problems with...
-
DRK303MK Timken Master Differential Bearing Kit for Chrysler 8.25" this is the kit I bought when I did my in my 2012 kk. I found that...
-
lfhoward replied to the thread Liberty 3.7 question.That’s where the EGR valve should be. Is that also a disconnected electrical connector I see in the photo? Also probably goes to the EGR.
-
lfhoward replied to the thread Rear Diff Ring gear bolts 8.25.In every regearing video I have ever watched, they got red loctite and got reused. Someone else with actual knowledge should respond…
-
Finally took my jeep to its natural habitat. The old libby handled the trails up to the ringing rocks in montana like a dream.
-
lfhoward replied to the thread What did you do to your jeep today?.I would play around with the 3 pin and see if I can make it work. In computer fans (very different, I know) a third wire is usually for...
-
Renegade overheated today… Did a little diagnosing and found that the radiator fan wasn’t working. I have a spare rad fan but that one...
-
lfhoward replied to the thread What did you do to your jeep today?.This is an idea. I think I will keep the parts and see if I can understand the failure mode, and later determine if the kit can be...
-
lfhoward replied to the thread What did you do to your jeep today?.They started out as Bilstein coilovers that JBA modified. Marlin had custom shock valving, custom springs, and a custom clevis. The...
-
lfhoward replied to the thread What did you do to your jeep today?.I checked out the carnage today. Actually it is not too terrible. The adjust a strut failed where the shock rod attached to the lower...
-
-
Mine sits a bit low at the front, even with 1/4" spacers fitted, the diesel is a heavy lump. When I get some spare time I'll add some...
