KJowner's latest activity
-
KJowner replied to the thread Need help selling a NSG370.Can't you swap the tail housing or use it with a separate transfer box? I doubt many people on here will want a 2wd box, the NSG was... -
Bon Giorno. You have a great number of the CRDs in your country. I'll be visiting Italy after the war in Ukraine is over to collect a...
-
Yesterday I ordered the Sasquatch in tank lift pump kit with their custom made 2005 wiring harness. Its a little expensive and if I had...
-
If you jump out starter relay pins #30 & #87 and starter motor cranks the engine, then most likely you have a bad starter relay or it is...
-
Our 2006 had this happen in the parking lot of Home Depot! Got the rig home and took the cover off the steering column. Adjacent to the...
-
-
My 2006 is at 206203 now and I am only a few months from owning it for 8 years and it had less than 90k then
-
KJowner replied to the thread 2008 3.7L Questions Jeep Newbie Daughter's truck down.....!.If you do go down the full engine or service exhange heads route there are several reviews on here for companies, might be worth a look...
-
KJowner reacted to fastmerc's post in the thread 2008 3.7L Questions Jeep Newbie Daughter's truck down.....! with
Like.
Waiting at the station here folks........... I'm thinking perhaps a valve train failure in #5 as compression is low.....but not... -
Thanks! It drives SO MUCH better than the mushy sacked out OEM suspension. The Deeke UCAs didn't come with washers and seemed to fit...
-
BDS 2" kit with Bilstein front shocks and Deeke UCAs - 21" front, 21 3/8" rear.
-
i will tell the neighbor. i got the latch and the handle with the microswitch at a wrecking yard and installed them. When I went to shut...
-
KJowner reacted to fastmerc's post in the thread 2008 3.7L Questions Jeep Newbie Daughter's truck down.....! with Like.
Thanks for the replies!!! This truck was an "unknown"...... Daughter and care of vehicles (how much she actually retained from dad...
-
KJowner reacted to WesStevens's post in the thread Passenger Side (right side) Axle doesn't seem to be in all the way with Like.
Yes, there is a snap ring on the inner axle shaft. It appeared to have seated correctly, but I'm going to remove it, and put it back in...
-
KJowner replied to the thread Passenger Side (right side) Axle doesn't seem to be in all the way.Isn't there a snap ring on the spline? Might not have seated
